Yoursme 2.5in UTV Front And Rear Lift Kit Installation Guide
- June 15, 2024
- Yoursme
Table of Contents
LIFT KIT
INSTALLATION INSTRUCTION
2.5in UTV Front And Rear Lift Kit
PRODUCT INFORMATION
This suspension jift kit will rise your UTV front and rear 2 inches. It fits
for 2014-2022 Polaris Ranger 500/570/CREW Midsize. Also can work on Polaris
Ranger Fullsize with front strut suspension only.
KIT CONTENT
FRONT INSTALLATION
Remove the nut from the top of the shock, removethe washer and rubber grommet,
and set them aside – Jack up the ATV by the body, the shock will drop down.
Remove the rubber grommet from the top of the shock – Screw on the aluminum
spacer onto the threaded rod that sticks out of the top of the shock – Replace
the rubber grommet onto the top of the spacer – Slowly lower the jack and
guide the shock through the mounting hole – Replace the top grommet, washer
and tighten the nut. Repeat on the other side.
REAR INSTALLATION
Open the dump bed and release the hydrologic catch to get the bed out of the
way. Remove the nut from the swing arm. Jack up one side at a time and remove
the spring from the top mount. install the new mount supplied over the top of
the frame as shown in pics and secure it with included small bolt.
Replace/install bolts supplied to mount shock/ spring in the new position.
Reattach the swing arm. Repeat on the other side.
AFTER INSTALLATION
Having all bolts/nuts checked for tightness after the first 500 miles and then
every 1000 miles or 3 months is highly suggested. And wheel alignment steering
system, driveline systems, suspension must be inspected by a qualified
professional mechanic at least every 3000 miles.
Note: All modifications must be installed by qualified personnel and in
compliance with your local modification regulations.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>