Guoquan A6PRO iPhone Bluetooth Headset Instructions
- June 15, 2024
- Guoquan
Table of Contents
A6PRO iPhone Bluetooth Headset
Ios
Open the Bluetooth
Open the earphone, near the unlocked phone
Search for the name of the Bluetooth Device Click on the connection
Android
Open the Bluetooth
Open the earphone, near the unlocked phone
Search for the name of the Bluetooth Device Click on the connection
Ear-to-ear contact
Play/pause (left/right ear touch)
one song (Secondary Ear touch twice)
next song (primary ear touch twice)
answer the phone (left/right ear touch once)
hang up the phone (left/right ear touch once)
reject the call (left/right ear press 2 seconds)
Note: iphone Button to enter Bluetooth name customization function
Main parameter
| Chip: JL | Music Time: 3-4 hours |
|---|---|
| Bluetooth version :BT5.3 EDR | Headphone standby time approximately: 100 hours |
| MATERIAL: ABS | Reception Distance: 15M(barrier-free environment) |
| Headphone battery capacity: about 35mAh | Horn diameter: 13 mm |
| Charging box battery capacity :200mAh protection plate | Bluetooth Protocol: |
HSP. HFPA2DPAVRCP SPP PEAP
Charging Times for both ears: About 3 times| Bluetooth Protocol: HSP.
HFPA2DPAVRCP SPP PEAP
Charging time: 1 hour| Horn impedance: 35 euros
Call Time: 2-3 hours| Horn sensitivity: 100 soil 3DB
Description of function definition
Basic function of earphone
Boot up: after the earphone is taken out, it will automatically start up and
automatically pair up
Shutdown: Put the charging bin and close the cover, and the headset will shut
down automatically
Single earphone use: Open the charging Bin, start the machine automatically,
connect the Bluetooth successfully, take out the single ear,
Cover the charging compartment before using the one-ear function
AUTO-CONNECT: In the phone did not delete the connection through the headset
matching name, open the cover can automatically connect back
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>