Grainger 443V93 Impulse Heat Sealer Instruction Manual

Table of Contents

Grainger 443V93 Impulse Heat Sealer Instruction Manual

NOTE:

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a persponsible for their safety.
Children should be supervised to ensure they do not play with the appliance
lf the supply cord is damaged it must be replaced by the manufacturer or similar qualified personnel in order to avoid a hazard.

DESCRIPTION OF EVERY PART

Grainger 443V93 Impulse Heat Sealer - DESCRIPTION OF EVERY
PART

PURPOSE

This impulse Sealer is to insure a water tight and air tight seal for effective autoclaving and sterilization procedure.

CONNECTION DIAGRAM

Grainger 443V93 Impulse Heat Sealer - CONNECTION
DIAGRAM

CHARACTERISTIC

Compact Design
Strong Water Tight Seal
Fast Operating
Power Saving
Precision Electronic Circult
Long Life

OPERATION

Plug cord into AC outlet. No switch necessary, Machine will operate only when arm is depressed. Regulate the timer according to thickness of material to be sealed. Use a higher-number for thicker mateiar Pull
handle down. Sealing takes place when light is on, Leave down for additional second after light goes off for a better seal.
Use a lower number in case seal burns through
Raise to higher number when seal isn’t tight
Should bag stick to silicon rubber, you did not give enough cooling time.
Once you set the time, no need to reset as the machine will remain constant and unchanged.
No need to remove plug from socket as machine will not operate until handle is lowered. No Power is consumed

NOTES

Always keep sealing platform clean. Leaving residue will reduce life of element, teflon, and silicon rubber.
Never use moisture to clean sealing surface.
Replace torn teflon at once. A torn cloth will short circuit the element and damage it. Every time you replace the element, replace the lower and upper teflon cloth.
Forbest operation, use only genuine replacement parts.
A worn silicon rubber will influence the seal, change the silcon when worn or burned.
Unplug wire when servicing the machine.

SPARE PARTS

Grainger 443V93 Impulse Heat Sealer - SPARE PARTS