Seneasy Intelligent SRC3925 Bluetooth Remote Control User Manual
- June 15, 2024
- Seneasy Intelligent
Table of Contents
Intelligent SRC3925
Bluetooth Remote Control
User Manual
RC-37 VIEW
FCC ID WARNING MESSAGE:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.
BLUETOOTH PAIR:
- Simultaneously press and hold the “back+home” button on the remote control for 3 seconds, the remote control clears pairing information, sends pairing broadcast, and the red light flashes at a frequency of 2Hz. If the pairing is successful, the red light on the remote control will remain on for 3 seconds; If pairing fails after 30 seconds, the red light will turn off.
- The pairing distance is between 20 centimeters and 1.5 meters.
- Bluetooth device name: “RC-37”.
- In factory testing, after the testing is completed, the testing software will issue a command to clear the pairing information of the remote control.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.