Dowshata 360 Photo Booth Machine with Flight Case Installation Guide
- June 15, 2024
- Dowshata
Table of Contents
Dowshata 360 Photo Booth Machine with Flight Case
Specifications
- Product Name: 360 Photo Booth
- Power Supply: AC100-240V
- Power Bank Output: DC5V
- Battery Specifications:
- Booth Remote: 23A 12V
- LED Remote: CR2025 3V
- Ring Light: 5V USB Portable Charger
INSTALLATION INSTRUCTIONS
-
Open the package and take out all the accessories.
-
Put the 360 photo booth upright. Adjust the height of the cushions to keep the 360 photo booth stable.
-
Put the shaft into the balance board. And fix it with 2 M8 screws on the left and right sides respectively.
-
The bending pole (with the box opening facing up) is mounted on the shaft. First use M8 screws to fix the left and right center positions. Adjust the appropriate angle, and then fix the edges on both sides with M8 screws
-
Install thincker pole + thinner pole or install thinner pole to the bending pole directly (thincker pole is not necessary)
5.1 Insert the thincker pole into the bending pole. The left and
right sides are fixed with 2 M6 screws respectively.
Then insert the thinner pole into the thincker pole. The left and right sides are fixed with 2 M6 screws respectively. By adjusting the corresponding hole position, the height can be adjusted
5.2 Insert the thinner pole directly into the bending pole. The left and right sides are fixed with 2 M6 screws respectively. By adjusting the corresponding hole position, the height can be adjusted -
Install the ring light on the head of the thinner pole. Tighten the head screws.
-
Plug the female connector of one out of three DC cables into the DC connector of the power supply. Plug the power cord and the power supply
-
How to install mobile phone, camera, and iPad (choose one of three)
8.1 Mobile phone installation. Install the phone holder assembly on the central screw hole of the ring light, pull out the
ends of the phone holder, and put the phone into the slot.
8.2 Camera installation. install the camera on the pan/tilt on the middle of the ring light. Tighten the gimbal screws.
8.3 iPad installation. Install the iPad holder assembly on the thinner pole and tighten the fixing screws. Press the button on the side of the stand and pull out the buckle. Put the iPad into the slot, and then tighten the buckle.
-
Put the power bank (DC5V output) in the bending pole box. Plug the USB plug of the ring light into the power bank.
-
nest the three plugs of the power cord into AC100-240V and the installation is complete!
NOTICE
- Reverse rotation and speed can be adjusted through the motor remote control. The color of the ambient strip light can be changed by the led remote controller.
- All batteries are not come with photo booth and need to be purchased by customer. Battery for remote control with lamp (battery specification CR2025 3V) Battery for motor remote control (battery specification 23A 12V) Battery for ring light ( battery specification 5V USB)
- The medium pole can be removed if needed, then connect the large pole with the small pole directly.
- All batteries are not included in the order. Buyer need to buy batteries for the ring light and the remotes.
The required batteries are as follows
- Note : All batteries are not come with photo booth and need to be purchased by customer.