GEEANN GA-001 Keypad Digital Deadbolt Installation Guide

GEEANN GA-001 Keypad Digital Deadbolt

Thank you for purchasing our products. Please review this manual thoroughly before operating your device. All pictures in this manual are for illustration purpose only. Actual product may vary due to product upgrade.

IMPORTANT: Do not load batteries until lock is completely installed.

TOOL REQUIRED

Do not use an electric screwdriver during installation

INSTALLATION OVERVIEW

Parts List

PREPARE DOOR AND JAMB

1. TEMPLATE
   • a. Take out the hole template (Figure 1a).
   • b. Fold the template and place the marker on the door(Figure 1b).
2. MARK THE DOOR FOR DRILLING
   • a. Mark center hole on door edge through guidance on template for 1″ (25mm) latch bolt (Figure 2a).
   • b. Mark center hole on door face through guidance on template for 2-3/8* (60mm) or 2-3/4″ (70mm) (Figure 2b) backset.
3. DRILL AND CHISEL DOOR
   • a. Drill 2-1/8* (54mm hole through door panel as marked for lock set (Figure 3a).
   • b. Drill 1″ (25mm) hole in center of door edge for Deadbolt Latch Assembly (Figure 3b).
   • c. Insert Deadbolt Latch Assembly in hole keeping it parallel to face of door. Mark outline and remove latch (Figure 3c).
   • d. Chisel 5/32* (4mm) deep or until latch face is flush with door edge (Figure 3d). NOTE: For Drive in Latch, drill hole size indicated on template and press until it is flush with door edge.
4. MARK AND DRILL DOOR JAMB
5. a. Mark center hole on edge of jamb even with the center of the Latch Bolt on door edge. (Figure 4a).
6. b. Drill 1″ (25mm) hole 1-3/16* (30mm) deep in door jamb on center mark (Figure 4b).
7. c. Outline outside edges of Strike Plate (Figure 4c).
8. d. Chisel 5/64* (2mm) deep for Strike Plate or until it is flushed (Figure 4d).
9. e. Install Strike Plate using two 3/4″ (19mm) screws provided (Figure 4e).

Tools Required

• Tools Required for Installation on undrilled Doors:
• Phillips Screwdriver (DO NOT USE POWER DRILL!)

Prepare the door and check dimensions

STEP

Install the latch and strike

STEP

• Use a screwdriver to test if deadbolt works smoothly.
• Install strike on the door frame.

Install exterior assembly

STEP

Install interior assembly

STEP

Detect left/right hand door installation
Reset the lock to teach the lock the orientation of the door.

STEP
IMPORTANT: This step is required and crucial for the lock to operate properly.

• While the door is OPEN and UNLOCKED, load 3 AA batteries into the battery compartment.
  Note: For long last, please use all new, non-rechargeable Alkaline batteries only.

• Press and hold the Reset button on the interior assembly by using the reset tool.

• Load the 4th battery and keep holding the reset button for 3 seconds, until you hear the sound of “beep”. The latch bolt will extend to learn the orientation of the door automatically.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>