Milfra B0C9GXJ85T Self Powered Wireless Light Switch Instruction Manual

B0C9GXJ85T Self Powered Wireless Light Switch
Instruction Manual

B0C9GXJ85T Self Powered Wireless Light Switch

Self-generating wireless kinetic energy switch Instruction manual
Wireless kinetic energy switch (1 keys)

Self-generating wireless kinetic energy switch 12070 is a no-wiring, no battery, wet operation, no longer worry about electric shock, easy to use and easy to achieve single control, dual control, multi-control, A  controller for mutual control, which can be used with receiving devices such as wireless receivers/smart switches for remote control of electrical equipment. The 12070 series uses innovative self-generating technology to collect the energy of the switching action for transmitting wireless signals, thus eliminating the need for batteries. It is more environmentally friendly to save the battery.
12070 controller specifications:

Note: The transmission distance is affected by the wall and may differ from the actual measured value.

301JS Receiver Specifications

Installation Notes:

< 1Controller section:
can be placed or moved at will, or fixed to your favorite location. Please try it in the desired fixed position before fixing, and it will not affect the normal use and then fix it. The fixing method is as follows:
(Mode 1),  double-sided stickers, as shown in the figure: stick the bottom surface of the switch with a double-sided sticker, and attach the other side to your favorite place. (Mode 2) Screw fixing, as shown in the figure: Open the top cover with a flat-blade screwdriver, put it on the fixed position, try to draw the positioning point normally, and then use the professional tool to punch the  rubber plug on the wall and fix the switch to the wall with the screw.

Special note: Please avoid installing on metal objects (iron doors, iron windows, etc.) to avoid affecting the launch distance. Please try if it is feasible before fixing.
< 2>Receiving part:
(Wiring part): As shown in the figure, please pay attention to turn off the power before wiring. Non-professionals should not electrify the wiring.

(Installation and fixing method):
As shown in the figure, it can be fixed by double-sided tape or screwed. Note: Can not be installed in the metal box, can not be close to the ground or large pieces of metal, otherwise it may not be able to receive wireless signals.

Instructions:

< Pairing>: If the 301JS receiver is in the power-on state, the indicator light is always on, it is in the pairing mode (no switch is saved), and pressed the button 2 times, the indicator light flashes and the pairing code is  successful. it can be equipped with up to 5 switches. You can also pair it yourself as shown below. When the receiver has been equipped with 5 switches, the new switch will automatically replace the first switch. Note: As long as the power is on, press and hold the button for 3 seconds at any time to enter the pairing mode. If there is no pairing switch within 10 seconds, the pairing mode will be automatically ended. You can  also press the button on the receiver to end the pairing. Usually press the button briefly to turn it on or off.
< Clear Pair Code> If you press and hold the button on the receiver as shown in the figure until the indicator light is on and flashes 3 times, all the pairs are cleared

Default On/Off >:

1. While the switch is on, if power is cut off by accident, the receiver is set as turned off by default when power is recovered.
2. If you want to set receiver as power on, please process operation as following. when power is recovered, turn on the switch by short pressing the button on receiver and make sure do not do any other operations  inflowing 10 seconds. the receiver will remember new setting as power on by default in next time.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>