CORIOLISS C-Extreme Professional Hair Straightener Instruction Manual

: June 14, 2024
: CORIOLISS

Table of Contents

Important Information
Operating instructions
Operation
Failure to operate
User maintenance instructions
Customers Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

CORIOLISS C-Extreme Professional Hair Straightener

Important Information

Important operating and maintenance instructions

Operating instructions

Plates
Ion indicator
Power ON/OFF key
Power cord

Operation

Plug your Corioliss into the power supply. At this point a POWER connection light comes on. The iron switches on by default at the last set temperature (170º white light – 190º green light – 230º red light).
To unlock the opening of the plates, slide the tab on the attached cable cylinder upwards.
Press the ON/OFF button to raise or lower the temperature. The temperature range indicator light will come on.
The blue light indicates that the ion generator is operating.
Switch off your Corioliss using the ON/OFF button. Then unplug your Corioliss from the mains and leave it in a safe place to cool down.

This tool is not only attractive for you, but also for children. Make sure you always store it properly, keeping it out of reach, particularly during use and while it is cooling down.

Failure to operate

In the unlikely event that your Corioliss product does not operate correctly, check that the Corioliss product and mains power supply are switched on, and that power is available.

Your Corioliss styler is a product designed to work at a high level. If while using it the device has gone through strong variations in the electrical power supply, can go into security mode to prevent possible damage.

Therefore, in the unlikely event that your Corioliss product does not operate correctly, check that the Corioliss product and mains power supply are switched on and that power is available. If the product stops working, follow these steps:

Turn off the styler.
Unplug the styler from the main power supply.
Wait for a few seconds and plug the device again into the main power supply.
Turn on the styler.
In the case of any repeated faults or problems, please contact Corioliss Service Center.

User maintenance instructions

CLEANING

Unplug your Corioliss styler from the mains power supply.
Always allow the Corioliss styler to cool before attempting to clean it.
Never immerse the appliance in water.
Wipe the outside and the plates with a damp cloth. Do not use sharp or abrasive detergents or corrosive products.
Do not use hair products that could leave residues on the plates.

STORAGE

Always allow the Corioliss styler to cool down before storing away.
When the Corioliss styler has cooled down, fold the power cord in the same way as it was first delivered in its packaging. Do not wrap the supply cord around the Corioliss styler as this can strain the cord and cause premature supply cord failure.