Yanko 23W01LU Smart Bath Mat User Manual

**Yanko 23W01LU Smart Bath Mat User Manual

**

Included thing

• Body

• Soft mat

• Charging cable

• Power adapter

• Users’ manual

Body

Indicator light

Blue Bluetooth connection available
Flashing blue Connecting to Wi-Fi
Flashing yellow Charging
Yellow Charging complete
Flashing green Auto Calibration

Button

Switch

Left ON
Right OFF

Reset Press and hold for 5 seconds

Placement

• Place the main unit horizontally on a hard surface near the bathroom doorway.
• Place the soft mat on top of the main unit.
• There is a non-slip sheet on the back and both sides of the soft mat.
  Hold it down so that it adheres to the main unit.

Setup

Step 1. Download the dedicated app

App Store, Smart Bath Mat” in the App Store or Google Play and download the dedicated app. Download the dedicated app.

Step 2. Administrator account registration

Start the “Smart Bath Mat” application and follow the instructions on the application screen to enter your profile and register an account. Follow the instructions on the app screen to enter your profile and register an account.

Step 3. Turn on the power switch of the body

Turn on the power switch on the back of the unit. Confirm that the light is blinking blue. If the light does not blink blue, the battery may be dead. Charge the battery and try again.

Step 4. Smart Bath Mat Initial Setup

Follow the instructions on the application screen to connect the Smart Bathmat to the detected Smart Bathmat.

Step 5. Wi-Fi Settings

After entering the Wi-Fi to which the Smart Bath Mat is connected and its password, tap the “Connect Wi-Fi” button. The light will turn off. Get on the Wi-Fi connection and take a measurement.

How to use

After getting on the unit, keep an upright posture for about 3 seconds until the measurement is completed. When the measurement is complete, a “beep” will sound.

FCC regulatory conformance:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>