warmsmart B0B7RC35T7 Rechargeable Electric Heated Insoles User Manual
- June 14, 2024
- warmsmart
Table of Contents
warmsmart B0B7RC35T7 Rechargeable Electric Heated Insoles
Product Information
The Heated Insoles are designed to provide warmth and comfort to your feet during cold weather. The insoles have a heating area made of PU, Mesh Velvet, and Super Fiber Cloth materials. The package includes three sizes: H (45/11.5), M (44/10.5), and L (43/10, 42/9, 41/8.5).
Specifications
- Voltage: 3.7V
- Battery Capacity: 3500mAh
- Charging Voltage: 5V2A
- Power Output Efficiency: 98%
- Overcharge Protection Voltage: 4.2V
- Overload Protection Voltage: 2.85V
- AC Adapter Input: AC/100V-230V, 40-60Hz
- AC Adapter Output: 4.2-5V, 500*2
Operation Instructions
To use the Heated Insoles:
- Charge the battery within 24 hours after it is used up. Failure to charge it in time may affect the battery’s life and startup.
- To save power, turn off the insoles when not in use.
- During storage, fully charge the insoles at least three times a month.
- To charge the insoles, plug the two charging cable plugs into the USB port on the back of the insole. The red light will indicate that it is charging. After approximately 3 hours, the red light will turn off. Note: Do not charge the insoles when they are turned on.
About Cleaning
To clean the Heated Insoles:
- Spot clean only. Do not soak them in water.
- The front and middle parts of the insoles can be washed, but avoid soaking the battery port in water.
- Wipe or scrub the battery port as much as possible.
Tips and Warnings
Before cutting the insoles according to your foot size, perform the following
steps:
- Turn on the insoles and adjust them to the high-temperature mode using the remote control or the temperature adjustment button on the insole.
- Place the insoles in a small closed box or under a quilt for 10 minutes.
- Check if the center of the foot in the heating area is heating normally and meeting your needs.
If you experience any discomfort while wearing the insoles, remove them immediately and contact our After-sales Service for assistance.
FAQs
-
Q: Can I cut the insoles below the indicated line?
A: No, do not cut below the indicated line. Cutting below this line may damage the functionality of the insoles. -
Q: How often should I charge the battery?
A: It is recommended to fully charge the battery every 3-6 months. -
Q: Can I charge the insoles while they are turned on?
A: No, it is forbidden to charge the insoles when they are turned on. -
Q: How should I clean the insoles?
A: Spot-clean the insoles using a dry flat method. Do not bleach, iron, wring, or soak them in water. -
Q: Can I immerse the insoles in water?
A: No, the insoles are not allowed to be soaked in water due to the built-in lithium battery.
Package List
About Battery
- After the battery is used up, please charge the battery within 24 hours.
- Failure to charge it in time will seriously affect the battery’s life and startup.
- When not using the product, please turn it off to save power.
- Please fully charge it during storage.(It is recommended to charge it 3 times in one month.)
Warning:
Please read the instructions carefully and operate the heated insoles under
the correct guidance, Failure to follow the instructions or operate the heated
insoles in a dangerous environment may result in injury. If you feel
uncomfortable when you wear it, please take off the insoles immediately. you
would be better to contact with our After-sales Service for more help.
Operation Instructions
Key operation on the insole buttons:
- When putting in the shoes, press the insoles “ “button for 3 seconds.
- After turning it on, press the button on the insole to adjust the temperature.
- Press “H” =High temperature(Red light), about 131-149°F;
- Press “M”=Medium temperature(Yellow light), about 122-131°F ;
- Press “L”=Low temperature (Green light), about 104-114°F;
- Turn-off: Press and hold the insoles on/off “ “button on the insole for 3 seconds.
Estimated Heating Time
- Red Light-Highest temp ( 55 -65°C/ 131-149°F ,5.5-6 hours)
- Yellow Light-Medium temp ( 50-55°C/122-131°F ,7-8 hours)
- Green Light-Lowest temp ( 40-45°C/ 104-114°F ,10-11 hours)
Charging And Working Time
- Please turn it off and recharge it.
- You need to plug the two charging cable plugs connected to the charger into the
- USB port on the back of the insole.
- When charging, the red light will be on.
- After about 3 hours, the red light will be off.
- Note: It is FORBIDDEN to charge when POWER ON.
About Cleaning
- Because this product has a built-in lithium battery, it can’t be soaked in water and is not allowed to be soaked in water. The front and middle parts can be washed, and the battery port should only be wiped/scrubbed as much as possible.
- It is forbidden to soak in the water.
- Note: This product is not allowed to be soaked in water
Product Details
Specifications
- Voltage: 3.7V
- Battery capacity: 3500mAh
- Charging voltage: 5V2A
- Power output efficiency: ≥98%
- Overcharge protection voltage: 4.2V
- Overload protection voltage: 2.85 V
- AC Adapter Specifications
- Charging mode: CC /CV
- Charging temperature; 0℃~ 45℃
- Input: AC/100V-230V 40-60Hz
- Output 4.2-5V 500*2
Tips and Warnings
After getting this product, turn it on, then use the remote control or the temperature adjustment button on the insole to adjust the high-temperature mode, then put the insole in a small closed box or quilt for 10min, and pay attention the center of the foot in the heating area, if it can heat normally and can meet the needs, then cut the product according to your feet size.
More Deals!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>