INTEX 64761E Dura Beam Standard Downy Air Mattress User Manual

FAQ

Q: If my air mattress has a leak, how can I find it and patch it?

A: First, make sure that the air mattress is leaking. Stretching is a natural characteristic of new vinyl and the first few times you use the mattress. Some stretching will occur suggesting that the mattress is losing air. It is simply stretching under your body weight and this is normal for the first few uses. To check the mattress for leaks, first make sure the valves are secure, replace it if necessary. You can also put liquid soap and water in a squirt bottle and spray on seams. If there is a leak it will bubble. (Laundry detergent and dishwasher detergent will not work; they do not have the “bubbling· effect) After you find the leak, clean and dry the leaking area, remove the flocking with fine sand paper or an emery board, then apply the repa ir patch that comes with your air mattress. Alternatively, you may purchase an lntex repair kit (#59632 or 11410) for additional patches. If the leak is located in the seam it cannot be repaired. How to repair the air mattress

Q: Does t he INTEX air mattress come with a warranty?

A: lntex air mattresses do not have a warranty. If you have any questions regarding the replacement of your lntex air mattress please contact the original place of purchase. Replacements are issued through the retailer in accordance to their store policy. For air mattresses purchased from www.intexstore.com please review the Warranty/ Return Policy section of the site.

Q: Since my air mattress has f locking, how can I use t he repair patch - it won't ad here to the flocking?

A: The repair patch is designed for vinyl surfaces only. However, fine sandpaper, or an emery board can be used to gently rub away the flocking. When that is complete, clean the area with nail polish removal solution so the repair patch will adhere to the bed. How to repair the air mattress

Q: What type of valve does my a ir mattress have?

A:The INTEX air mattresses have a Built-In Pump, a 3-in-1 Valve (part# 10650), a 2-in-1 Valve (part# 10651), or a Double Valve. An Exhaust Valve Cap (part# 10043) and Plug (part# 10044) is also used on some old type air mattresses.

Q: How can I d iffe rentiate the valves?

A: A Built- in Pump is a pump that is mounted inside of the air mattress with the panel portion showing. A 3-in-1 (part# 10650) Valve has two “clips” on either side of the Valve Cap that allows for easy removal. A 2-in-1 (part

10651) Valve does not have “clips” and instead consists simply of a screw-on

cap, and a plug that fits on top, and in the center of the cap itself. The Exhaust Valve Cap (part# 10043) and Plug (part# 10044) consists of a rubber stopper plug that is inserted first, while the screw-on cap is placed on top of the plug. The Double-Valve is a vinyl valve stem that is attached to the mattress and is reminiscent of a beach ball valve. Valves Ident infixation

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>