Nttworks SUD-100H Data Transceiver User Manual
- June 15, 2024
- Nttworks
Table of Contents
Nttworks SUD-100H Data Transceiver User Manual
Specifications
| Model | SUD-100H |
|---|---|
| Frequency | 433.42MHz |
| Rx Sensitivity | -115dBm |
| RF Power | Below 10mW |
| Modulation | FSK |
| Power | 5Vdc |
| Size | 17(W) 60(L) 38(H) |
| Weight | 24g |
| Operating Temperature | 0 ~ 50℃ |
| Relative Humidity | 0 ~ 80% |
Summary
The device is RF transceiver that is able to receive and transmit RF signal. It communicates with the device via RS232 communication. The received RF data is forwarded and delivered transmission command from the equipment will be conducted.
How to Use
Connect the connector of this device and the connector of the equipment. RF data is transmitted and received through the designated protocol.
Product
SUD-100H
FCC Information
This device complies with part 15 of the FCC Results. Operation is subject to
the following two conditions:
(1) This Device may not cause harmful interface, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the Interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment Into an outlet on a circuit different from that to which receiver Is connected.
- Consult the dealer or experienced radio/TV technician for help.
WARNING
Changes or modifications not expressly approved by the manufacturer could
void the user’s authority to operate the equipment.
CAUTION : Exposure to Radio Frequency Radiation.
Antenna shall be mounted in such a manner to minimize the potential for human
contact during normal operation. The antenna should not be contacted during
operation to avoid the possibility of exceeding the FCC radio frequency
exposure limit.
IMPORTANT NOTE:
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>