AceClamp 119040 Snow Retention Bracket Instruction Manual
- June 13, 2024
- AceClamp
Table of Contents
AceClamp 119040 Snow Retention Bracket Instruction Manual
IMPORTANT
We recommend using the fasteners designed for the specific roof on your building. Contact the fastener manufacturer for instructions on type of thread, depth of penetration, etc. The material should be compatible with your environment to avoid future corrosion.
instructions
STEP1 Review the AceClamp recommendations for the calculated oncenter
distance between brackets described in the quotation or on the roofing layout,
if one was provided. Mark that location on your roof. If the brackets are
intended to be fastened into the joists, it’s important that the joist
centerlines be determined and marked on the roof surface.
STEP2 Using the bracket as a template, pre-drill holes through the roof
covering and into the joists according to the fasteners you have chosen.
STEP3 Using a roof sealant that is compatible with the roof covering,
apply a small amount into each predrilled hole as a sealant against leaks.
STEP4 These brackets include a neoprene gasket that should be positioned
under the bracket before it is fastened into the roof joists.
STEP5 Flash around the bracket and seal the fastener heads using the same
sealant.
STEP6 Follow the www.aceclamp.com on-line instructions for the
installation of the tubing, collars and other accessories.
Photos shown are for representative purposes only. Actual product may vary. Design subject to change without notice. Always use OSHA approved safety equipment and procedures when working on a roof. Not responsible for typographical errors. V080122
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>