BathFun B0CGCVGTSF Automatic Waterproof Pump User Manual
- June 13, 2024
- BathFun
Table of Contents
BathFun B0CGCVGTSF Automatic Waterproof Pump
Operating instructions
- The product has a travel-locking function. To open the product, press and hold the power button for 3 seconds, and the LED light will be on.
- Press the middle button to start pumping. Continue to press the button until it switches to the required speed (three pumping speeds in total).
- After reaching the required pressure, click the power button to stop pumping. To resume suction, click the middle button once again.
- To gradually release the pressure, lightly touch the air release button at the bottom.
- To release all pressure, press and hold the bottom air release button.
- To turn off the product, press the power button for a long time, the LED light will turn off, and all the pressure in the pump will be released.
- If you want to accelerate the air release speed while using underwater, pls just expost the top outlet hole to the water.
Charge
When charging, the LED light flashes. When fully charged, the LED light stops
flashing and remains bright.
- Full charge time: 2.5 hours
- high-speed running time: 160 minutes
- low-speed running time: 180 minutes
Caution: Not intended as a medical device. No medical claims are made or implied. Be careful to reach the minimum effective pressure (not too high) during use. Not intended for prolonged use. Discontinue pumping if discomfort occurs.
Read User Manual Online (PDF format)
Loading......