LEAF4GO 5 Inch Gutter Cover Installation Guide
- June 13, 2024
- Leaf4Go
Table of Contents
LEAF4GO 5 Inch Gutter Cover
Product Description
Left to Right: Work left to right as viewed from the ground. Lay Leaf4go gutter cover completely flat over your existing gutters with the front edge of the guard lined up with the top front edge of the gutter and the back edge lying on the drip edge.
Installation Instructions
Use screw holes along the front and back edge of Leaf4go gutter cover to zip screw the panel – 3 screws (1, 2 & 3) to the front lip of the gutter and 2 screws (4 & 5) through the rear edge. DIAGRAM 2: This shows where to screw along the back edge of Leaf4go gutter cover to secure your gutter guards in place.
FOR INSIDE CORNERS: For 5″ Leaf4go gutter cover, measure 5 inches in from the end of the piece and put a mark on the front edge of the guard. From the mark, cut a 45 degree angle from the front edge of Leaf4go gutter cover to the back drip-edge. Trim the sharp corner of the front edge, about 1 inch in. Repeat for the other piece, excluding trimming the corner. Place this piece on top of the other, lining up the holes to allow for screws. Zip screw to gutter and you now have a seamless connection. (For 6″ Leaf4go gutter cover, measure inches.)
FOR OUTSIDE CORNERS: For 5″ Leaf4go gutter cover, measure 5 inches in from the end of the piece and put a mark on the back drip-edge of the guard. From the mark, cut a 45 degree angle from the back drip-edge of Leaf4go gutter cover to the front edge. Trim the sharp corner of back drip-edge about 1 inch in. Repeat for the other piece, excluding trimming the corner. Place this piece on top of the other, lining up the holes to allow for screws. Zip screw to gutter and you now have a seamless connection. (For 6″ Leaf4go gutter cover, measure 6 inches.)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>