PROFLO PF1831CP 24 in Towel Bar in Polished Chrome Instruction Manual
- June 13, 2024
- PROFLO
Table of Contents
PROFLO PF1831CP 24 in Towel Bar in Polished Chrome
Product Information
The product is a set of bath accessories that includes towel bars, towel rings, and a paper holder. It is available in different models: PF1831CP, PF1831ZBN, PF1841CP, PF1841ZBN, PF1851CP, PF1851ZBN, PF1890CP, and PF1890ZBN.
Product Usage Instructions
- Before installation, make sure you have the following tools: a Phillips screwdriver, a drill with a 1/4 inch bit (for drywall), and a level.
- Unscrew the set screw at the base of each post (marked as A and D in Fig. 1) to place the desired location for the 24-inch towel bar. Lightly mark the outline of the post on the wall and drill 1/4 inch holes per Fig. 1.
- Center the mounting bracket horizontally in the outline of the posts and verify the mounting point with a level (Fig. 2).
- Drill a 1/4 inch hole in the drywall and push in the plastic anchors flush into the drywall. Fasten the mounting bracket to the wall with a wood screw (Fig. 3).
- If mounting into a wood wall, fasten the mounting bracket flush into the wall with a wood screw without drilling holes (Fig. 4).
- Place the post over the mounting bracket and secure it with set screws (Fig. 5).
Product Part Information
- Towel Bar : Includes a mounting bracket and wood screws. Part number: OBPF100072 or OBPF100330 (depending on the model).
- Towel Ring : Includes a mounting bracket and wood screws. Part number: OBPF100072.
- Paper Holder : Includes wood screws. Part number: OBPF100329.
Please refer to the user manual for more detailed instructions and diagrams.
Caution-Tips
Thank you for choosing our product for your home. Please read these
instructions carefully before installing your new bath accessories.
You may need
Assembly Instruction
Unscrew Set Screw at base of each post . Per Fig.1, marking (A and D) to place the desired location for 24″ Towel Bar. Posiiton on wall where desired.Lightly mark outline of Post and drill 1/4″ holes per Fig.1.- Center Mounting Bracket horizontally in outline of Posts. Verify Mounting Point with Level. Fig. 2.
Drill 1/4″ hole in the drywall. Push in Plastic Anchors flush into the drywall. Fasten Mounting Bracket to wall with Wood Screw. Fig. 3.- If mounting into a wood wall, Fasten Mounting Bracket flush into the wall with Wood Screw without drilling the holes.Fig.4
Place Post over Mounting Bracket and secure with Set Screws. Fig. 5.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>