Arlux 200407 Rouleau Strip Led Instructions
- June 13, 2024
- Arlux
Table of Contents
200407
Rouleau Strip Led
Instructions for use
SERIE_R
General safety instructions
Light source (LED only) not replaceable
Non-replaceable power supply
This product contains alight source of energy class:
Electrical products must not be thrown out with domestic waste.They must be
taken to a communal collecting point for environmentally friendly disposal in
accordance with local egulations. Contact your local authorities or stockist
for advice on recycling.
Not compatible with a dimmer
Class II, double insulated, earthless
**** Product conforms to European Union Directives
-The installation manual does not replace local and (inter)national regulations for electrical installations. The product must be installed by a professional electrician following the customary and appropriate electrical codes and the instructions provided by the supplier, to avoid any risk of combustion or electric shock. Before installing, servicing or cleaning the product, always turn off the power at the main panel.
– Before use, ensure that the product has not been damaged. If deterioration
is observed, do not use the product.
– Do not look directly at the light source.
– Never touch the product when it is in operation, or when it has just been
switched off.
– Do not initiate repairs yourself as this will void the warranty.
– In order to optimize the light, clean the optics as well as the reflective
materials after the product has been switched off and after waiting for it to
cool down.
– Do not cover with heat insulating material.
– Do not turn on the product when the tape is wrapped around the reel. Unroll
the entire LED ribbon before use.
– Operating voltage 220-240 V. Connect the product to a stable electrical
installation, protected from overvoltages and leaks.
– Do not place the 230 V rectifier in a damp place or in water.
– Do not install the product in a flammable or explosive environment.
– Do not fix the LED strip with a metal support. Use the flexible fasteners to
hang the ribbon on the metal hooks
– Do not bend or twist tape with a smaller bend diameter at 8cm.
– Do not install the LED strip in a confined environment.
– Do not cover or wrap the LED strip.
– Do not crush or exert pressure on the tape when using it. 