EPICORE BIOSYSTEMS ASY-0215 Wearable Hydration Sensor Instructions

June 13, 2024
EPICORE BIOSYSTEMS

EPICORE BIOSYSTEMS ASY-0215 Wearable Hydration Sensor

Product Information

  • Model: ASY-0215
  • Manufacturer: Epicore Biosystems, Inc.
  • Address: 810 Memorial Drive Suite 100, Cambridge MA 02139, USA

Regulatory Information

  • United States FCC ID: 2BANDCHASY0215

FCC Compliance Statements
Any modifications made to this device that are not approved by Epicore Biosystems, Inc. may void the authority granted to the user by the FCC to operate equipment.
For Class B – Unintentional Radiators: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  • This device may not cause harmful interference and
  • This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio waves and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Radiation Hazard
The maximum output power, antenna gain, and minimum separation distance of this product were determined to be below the threshold and are exempt from SAR (Specific Absorption Rate) requirements according to the FCC SAR Exemption Criteria (FCC Title 47 CFR Part 1.1307, 2.1093) and the ISED SAR Exemption Criteria (RSS-102 Issue 5).

Battery Safet
Warning: There is danger of explosion if batteries are mishandled or incorrectly replaced. – On systems with replaceable batteries, replace only with the same manufacturer and type or equivalent type recommended per the instructions provided in the product service manual. – Do not disassemble batteries or attempt to recharge them outside the system. – Do not dispose of batteries in fire. – Dispose of batteries properly in accordance with the manufacturer’s instructions and local regulations.

Product Usage Instructions

  1. Onboarding Instructions
    • Go to epicore.ch to review instructional training videos.
    • Install Epicore CH from the App Store. – Reference video for help.
    • Follow instructions in the app to complete setup. – Reference video for help.
    • See your local health & safety representative for the Enterprise ID.
  2. Launch Connected Hydration Mobile App
    • Go to Settings > Legal & Regulatory. Please note that the above information and instructions are based on the provided text-extract from the user manual. For more detailed and specific guidance, please refer to the complete user manual or contact Epicore Biosystems, Inc. directly.

ONBOARDING INSTRUCTIONS

  1. Go to epicore.ch to review instructional training videos.
  2. Install Epicore CH from the App Store.
  3. Reference video for help.
  4. Follow instructions in the app to complete setup.
  5. Reference video for help.
  6. See your local health & safety representative for the Enterprise ID.

REGULATORY INFORMATION

  • Model: ASY-0215
  • United States: FCCID:2BANDCHASY0215

Epicore Biosystems, Inc.
810 Memorial Drive Suite 100, Cambridge MA
02139, USA

E-LABEL INFORMATION
Launch Connected Hydration Mobile App
Go to Settings → Legal & Regulatory

FCC COMPLIANCE
Compliance Statements

ATTENTION
Any modifications made to this device that are not approved by Epicore Biosystems, Inc. may void the authority granted to the user by the FCC to operate equipment.

ATTENTION
For Class B – Unintentional Radiators:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.

ATTENTION
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna
  • Increase the separation between the equipment and receiver
  • Connect the equipment into an outlet on a circuit different form that to which the receiver is connected
  • Consult the dealer or an experienced radio/TV technician for help

RADIATION HAZARD
The maximum output power, antenna gain and minimum separation distance of this product was determined to be below the threshold and is exempt from SAR requirements according to the FCC SAR Exemption Criteria (FCC Title 47 CFR Part 1.1307, 2.1093) and the ISED SAR Exemption Criteria (RSS-102 Issue 5).

WARNING
There is danger of explosion if batteries are mishandled or incorrectly replaced. On systems with replaceable batteries, replace only with the same manufacturer and type or equivalent type recommended per the instructions provided in the product service manual.
Do not disassemble batteries or attempt to recharge them outside the system. Do not dispose of batteries in fire.
Dispose of batteries properly in accordance with the manufacturer’s instructions and local regulations.

WARNING
DO NOT INCINERATE or subject battery cells to temperatures in excess of 212°F. Such treatment can cause cell rupture.

WARNING
EXPLOSION HAZARD – BATTERIES MUST ONLY BE CHANGED IN AN AREA KNOWN TO BE NON-HAZARDOUS.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals