TRUPER LARE-2000 High Power Rechargeable LED Lamp User Guide

LARE-2000 High Power Rechargeable LED
Lamp User Guide

LARE-2000 High Power Rechargeable LED Lamp

Instructive
102418 LARE-2000

SPECIFICATIONS

Uses two a Li-ion (2 600 mAh) rechargeable battery’s 7.4 V DC (of 3.7 V DC everyone) included.
USB car adapter
Input voltage: 12vDC lo 24 V DC
Input current: 0.6 A
Output voltage : 5 V DC
Output current: 1 A
Read and follow all warnings and instructions in this instructive.

• To avoid potential eye damage, never look straight into the light source when spotlight is turned on! Also, never aim the light straight into the eyes of anyone else!
• Never place spotlight face down when light is on or is still hot from recent use. Doing so could burn/ignite surfaces such as seats, carpeting, etc. and cause major property damage. Always turn spotlight off when not in use.
• Always unplug charger from light and power source when not in use.
• DO NOT touch lens of spotlight when light is on or if it was recently on. The lens will be hot and could cause serious burns.
• DO NOT allow children to handle or operate this spotlight.
• D0 NOT use this product for other than it’s intended use.
• D0 NOT charge or operate in close proximity of combustible or flammable materials.
• DO NOT charge battery in gas tight enclosures.
• D0 NOT attempt to plug the two ends of one cable into the two ports of the spotlight at the same time. Doing so will damage that battery and the charge.
• DO NOT attempt charge or operate this spotlight if cord, plug, battery bulb or any part of the spotlight is damaged or corroded.
• DO NOT use an outdoor AC outlet to recharge battery.
• To prevent accidental electrical shock we recommend this product always be charged on a GFCI (Ground Fault Circuit Interrupter) outlet.
• Only use charging devices that are provided with the LED Spotlight or it’s replacements.
• DO NOT disassemble or tamper with the battery.
• DO NOT dispose of battery in tire as this may result in explosion.

USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR SPOTLIGHT.
FAILURE TO AOHERE TO THE SAFETY WARNINGS AND GUIDELINES IN THIS INSTRUCTIVE COULO RESULT IN BODILY INJURY OR PROPERTY DAMAGE.

• Recharge battery fully before first use
• DO NOT leave battery uncharged for extended period (recharge the battery every 6 months).
• The normal charging time is about 56 hours (never charge longer than 12 hours continuously).
• DO NOT attempt to plug the two ends of one cable into the two ports of the spotlight at the same time. Doing so will damage the battery and charge.
• Never dismantle the battery parts.

OPERATING INSTRUCTIONS

Inspect contents of the box to ensure all parts are included and undamaged.

PART LIST

1. LEO Premium spotlight
2. Red light filter
3.  USB-C charging cable
4. 12 V DC lo 24 V DC USB car charger

TO OPERATE

1. To turn the unit on; fully depress the trigger button. Spotlight will default to “HIGH” mode.
2. To cycle modes (HIGH / LOW / SOS); fully depress trigger button and release.
3. Once the unit has been on a mode for 3 seconds the next trigger press will turn unit off.
4. To turn on the flood light al any time; press and hold the trigger button until flood light turns on (-3 seconds). Can be used in conjunction with main light.
5. To turn flood light off; press and hold trigger button until flood light turns off (-3 seconds).

NOTE
Once the desired mode is reached slide the mode lock down to lock the trigger button lo prevent unintentail button presses. To unlock slide the mode lock up toward top of spotlight.

TO CHARGE SPOTLIGHT
Step 1: Locate and unscrew battery cap on back of spotlight.
Step 2: Plug USB-C end into the USB-C port on back of unit and USB A end into power source.
Step 3: Charge indicator lights will flash to indicate status. When all lights show solid battery is fully charged (56 hours with 5V 1A input). Tri Function LED indicators: Blue LEDs located at back  of spotlight (reference illustration below)  provide battery status, indicate when battery is charging & complete, spotlight is working, and the power bank is activated.
Step 4: When unit is done charging replace the charging cable in the storage compartment and re-install the battery cap and tighten (do not overtighten).

TO CHARGE OTHER OEVICES
Step 1: Plug USB A end charging cable into the USB-4 battery bank port and the other end into your device. If the device does not start charging you may need to click the battery status check button lo initiate charging.
Step 2.: Push the button at back to activate the USB 2.0 output as power bank. When done push the button one more time to turn off the charging function. Always switch off when not in use to avoid self discharge.
USING/REMOVING RED-LIGHT FILTER
Step 1: Locale the preinstalled red-light filter on the front of spotlight and pull filter straight away from the light housing end of spotlight to remove.
Step 2: To re install the red light filter align the locking tabs on the side of the filter to either side of the light housing and push the filter into place until the filter is fully seated. There will be no audible/felt click so be careful to not press to hard as this may damage the filter.

TO REPLACE DC PLUG FUSE
Step 1: Disconnect spotlight from power source.
Step 2: Unscrew cap of DC plug and pull out of fuse holder.
Step 3: Pull fuse and fuse holder out of DC plug.
Step 4: If fuse is burned, out damaged or missing, insert a new 5A fuse into the fuse holder.
Step 5: Insert fuse holder and fuse into DC plug.
Step 6: Screw cap onto DC plug.

Spotlight

TO PREVENT DAMAGE TO SPOTLIGHT ANO BATTERY

• Recharge battery fully before first use.
• Do not attempt to use spotlight while charging directly from AC outlet. Doing so may cause damage to battery and AC charger.
• D0 NOT attempt to charge battery using both AC and DC chargers at the same time. This will damage the battery and chargers.
• Only use charging devices that are provided with the rechargeable LED Spotlight or its replacements.
• Do not allow battery to completely discharge. A dim light indicates a low battery. Recharge battery as soon as possible after each use.
• Always keep the battery fully charged when not in use.
• For best results, fully charge battery after each use. This will prolong the overall life of the battery.

A damaged battery can leak acid. Avoid contact with eyes and skin.
If contact occurs, flush immediately with large amounts of water.
D0 NOT ingest. If contact with eyes or ingestion occurs, consult physician immediately.

Charge battery before storing for extended periods.
Battery will keep its charge. A completely discharged battery may
not recharge properly.

MAINTENANCE

Use only soap and damp cloth lo clean the outer housing. Never let any liquid get inside the housing.
Contains lithium-ion battery.
Battery must be recycled or disposed of properly.

ENVIRONMENTAL PROTECTION

Waste electrical products should not disposed of with household waste. Please recycle where facility exist. Check with your local authority or retailer for recycling information.

Imported by Trooper, S.A. de C.V.
Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec,
Edo. de Mix. C.P. 54257 Made in China,
Tel.: 76 1782 9100. www.truper.com
012023

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>