AnablepSecurity A11SEC11 Wi-Fi Sensors User Manual
- June 13, 2024
- AnablepSecurity
Table of Contents
A11SEC11 Wi-Fi Sensors
User Manual
A11SEC11 Wi-Fi Sensors
AnablepSecurity Wi-Fi Sensors are for home and office. This document will
provide you setup instructions.
Power up the Anablepid Security base unit using built-in AC wall adaptor.
Power light will turn on blue. Use a laptop or phone, Go to settings > Wi-Fi
and look for “Anablepid Security” Wi-Fi network. Click and connect to this Wi-
Fi Network.
Open a Web Browser and enter 192.168.4.1 in the URL to open an AnablepSecurity
Sensor Setup page.
Here you will select your local Wi-Fi and Enter the Wi-Fi password.
Enter email address where you will receive welcome emails and notifications.
Enter the Sensor Name and click Connect so that AnablepSecurity Sensor
connects to internet..
Check for Welcome email from AnablepSecurity Team in your email box. Please
follow the instruction son creating a cloud account and then signing on to the
cloud.
On Cloud, you can monitor your AnablepSecurity Sensors. You can also change
AnablepSecurity Sensor Settings.
If your local Wi-Fi settings change or you move the AnablepSecurity Sensor to
a new location, pleasers WPS button for 10 seconds on the AnablepSecurity
Sensor to update Wi-Fi Settings.
You can follow the above steps again to setup AnablepSecurity Sensor again.
Please contact us if you are not able to resolve any issues.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This modular complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator and your body.
Steadfast Technology LLC /ADS-BLEnRF1-ANT2.412 GHz – 2.462GHz: -0.5dBi
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>