GRAVITIS 2AWVU Wireless Car Charger User Manual
- June 13, 2024
- GRAVITIS
Table of Contents
GRAVITIS 2AWVU Wireless Car Charger User Manual
Wireless Charger
Step 1: Locate the micro-USB cable included in the Gravitis packaging.
Connect the micro-USB end of the cable to the bottom of the unit, and the USB
end to your vehicle’s port. The red LED indicator on the back of the unit will
light up once connected.
INTRODUCTION
Your new Gravitas wireless charger is designed to mount to your car, allowing for hands-reef use of your phone. It can also charge wireless charging- compatible phones at the same time.
Please read this user manual before operating your new Gravitis wireless charger to ensure safe and proper use.
COMPONENTS
-
Cross brackets.
-
Vertical brackets
-
Rotary shaft
-
Mount
-
USB port
-
LED indicator
Step 2: Place your mobile phone o the bracket. The LED light will turn blue once the unit is in charging mode. Your phone will automatically start charging once connected to the Gravities device.
NOTE: You may need to adjust the length of the vertical brackets to !
accommodate a larger phone and properly align the charging coil of the phone
with that of the Gravitis device.
Step 3: Remove your mobile phone from the Gravities unit once it is fully charged
PRODUCT USAGE
Phone Holder:
Step 1: Attach the Gravitis device to your car’s air vent using the silicone mount on the back of the device.
Step 2: Place your phone against the device in between the cross
brackets. The weight of your phone will automatically adjust the position of
the cross and vertical brackets for a secure fit
PRODUCT SPECIFICATIONS
- Unit size: 4.13%3.94 x 0.68 inches Input: 5V/2A
- Output: SVIA
- Charging time: ~ ~2-4 hours (depending on model of phone)
- Material: PC/Silicone / ABS
SAFETY POINTERS
- Please keep this charger away from water or other liquids.
- If the charger needs to be cleaned, please first make sure it is disconnected from any power supply.
- This charger should only be operated within the temperature range of 32-113°F (0-45°C),
- Any physical impact to this device such as dropping the unit can cause malfunction.
- Please keep this device out of reach of children and animals.
This device complies with part 16 of the FCC Rules. Operation i subject o e following two condoms: (1) Tis device may not cause hamaul interference, and (@) s device must accept any interference receive, inkling deference that may cause undesired operation
FGC Caution:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply wt. the limits for a Class B digital device, pursuant to part 15 of the FOG Rules. These limits are designed to provide reasonable protection against harmful interference in a evidential installation. This equipment generates, uses and can radiate radio frequency energy and, i not installed and used in accordance with the instructions, may cause harmala interference to radio communications. Hover, there i no ‘guarantee that interference will not occur in a particular installation. If this equipment does cause harm fulinerference to radio or television reception, which can be determined by taming the equipment to and on, the user s encouraged to y to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outie on a circuitdiferent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/live technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>