Stalwart 65-E178 Electronic Safe User Manual

Stalwart 65-E178 Electronic Safe User Manual

Product Overview

1. Locking bolts
2. Storage hooks(NOT for override keys)
3. Battery compartment
4. Reset Button
5. Master Knob
6. Emergency override key cover
7. Control panel
8. (C) (E)Enter Buttons

Opening your safe for the first time

Use your emergency key the first time you open your safe, if you don’t know the codes, or if there is an electronic circuit malfunction.

1. Remove the emergency lock cover.
2. Insert the emergency key and turn it counterclockwise.
3. Turn the knob clockwise to open the door.

Installing the batteries

1. Open the door.
2. Open the battery compartment and insert four A batteries. Make sure that The batteries match the + and – in the compartment.

NOTES: Replace the batteries if the low battery light is on.
When an outage, the user code will be factory code “is9”, and need to reset the user code.

Setting the user code

1. With the door open, press the Reset button. You will hear two beeps and a yellow light goes on.
2. Input the new code (3-8 digits) on the keypad, then press the “c” or “F” button to confirm with 2 buzzer beeps, If the yellow light flashes with 3 buzzer beeps, the code reset is not accepted and you need to try again.
3. Before you close the door, try the new code to make sure it works.

Setting the master code

1. Open the safe, input “O” twice, and press the reset button, Start setting the code when the yellow light goes on.
2. Input the new master code (3-8 digits), then press the “C ” or “E” button to confirm, that it will be confirmed by 2 beeps and the yellow light flashes two times, then the setting is done successfully.
3. If the yellow light flashes three times, it means the new code is invalid and should be set again.

Opening your safe – after the first time

1. Input your user’s code (3 to 8 digits), each pressing results in one buzzer beep, and yellow light flashes.
2. Press the “C” or “E” button, and the green light will be on.
3. Rotate the knob clockwise within 5 seconds, the door is opened.
   Note: The user preset code “159. Please input the user code again if the yellow light flashes with three buzzer beeps.

Locking the safe
Close the door, then turn the knob counterclockwise to lock it. Automatic lock when wrong code entry

1. 3 continuously wrong entries will activate the warming beep for 20 seconds.
2. Another 3 continuously wrong entries will activate the warming beep for 4 minutes and 30 seconds

CAUTION: The keypad will be disabled during the beeping. You can only stop the
beeps by opening the safe with an emergency key and power-cut by removing the battery.

Securing the safe
Fix the safe in a place that is not easy to move.

1. Drill holes for expansion bolts(or clamping screws) in the right place.
2. Turn the expansion bolts counterclockwise to separate.
3. Use the expansion bolts (or clamping screws) to secure the case to the wall or floor.
4. Make sure the case is mounted in place as required and then tighten all screws.

Troubleshooting

• The site won’t open. When I enter my code
• Make sure want enter the correct source
• Prest the ” an “E alter entering the code
• You might be in lockout mode waiting minutes and ire pair

Repiace the basteries

• The door won’t shut
• Make sure there are no constructions
• If the door bolts are extended, re-enter the user code and turn the knob clockwise to retract them.
• Both the yellow and green clients are on at the same time

Replace the batteries

1. The warning light is flashing. Make sure vou entered the correct code
2.  Press the ” or ” button after entering the code Safety and Compliance
3. To reduce the risk of theft, the safe must be affixed to the wall or floor, mounting process be so pace, securing the state. nos put the emergency keys inside the sale, otherwise, vou can not open the safe with emergency
4.  Do not place the product in an insecure and elevated place, lest it may ah over and damaged.
5. Never try to dismantle the product by yourself Unzviced dismantling and incorrect reassembling of the inside or back cover may damage the electrical circuit and affect its performance

Download PDF:Stalwart 65-E178 Electronic Safe User Manual

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>