Lamvip VIPWL-09A 3FT 2PC LED Whip Light Installation Guide
- June 4, 2024
- Lamvip
Table of Contents
Lamvip VIPWL-09A 3FT 2PC LED Whip Light
PARAMETER
- Model# VIPWL-09A
- LED WHIPS 1 x 3ft
- Function APP+ Bluetooth +Remote Control
- Model# VIPWL-09A
- LED WHIPS 2 x 3ft
- Function APP+ Bluetooth +Remote Control
DOWNLOAD APP SOFTWARE
please search BT-lightinmajor apocenters, or scan below QR code
-
Download the “BT-Light “APP with your mobile phones by scanning the QR code on user manual or search
the “BT-Light” APP in iPhone APP store or Google play store. -
After the APP are downloaded successfully, you need to turn on Bluetooth function on your phone Trstly, then
plug in the straylight, then open the APP, your APP will pair with the strip light automatically and you can control it.
☆Android phones need to open the location function and allow permission
Unable to Connect Troubleshooting
- Check if the power supply of the light strip is normal.
(2) Check if the Bluetooth is turn on.
(3) Check if there are other mobile phone are connected, Bluetooth 4.0 only support connections one to many,
dose not support many to many.
(4) Check APP Bluetooth setting if the phone is connected to the device, if connect, exit the APP and reopen, the
APP will go to connect automatically.
(5) Normal operations and can not connect, please exit the APP and reopen.
(6) Exit APP, restart mobile phone, power on the strip light, reopen the APP, then them will connect automatically
INSTALLATION STEPS
- Click the menu icon, enter the “setting” interface
- enter“ BT connect”
☆The APP function introduction is shown in the truer above.
REMOT
FCC Warning
Any Changes or medications not expressly approved by the party responsible for
compliance could void
the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired toleration
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment of and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit deterrent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>