Vidami Pro Tools MODE Flat Surface and HOLD Loop User Guide

Pro Tools MODE Flat Surface and HOLD Loop
User Guide PROTOOLS MODE & FUNCTIONS GUIDE (PC)

PROTOOLS MODE

To switch to PROTOOLS MODE, place Vidami Blue on a flat surface and HOLD Loop and Play/Pause as you TAP Back. The blue LED will blink 3 times to show that you successfully changed modes.

PROTOOLS MODE FUNCTIONS

NOTE
To check which mode your Vidami Blue is in, open a blank document on your computer or iOS device and place cursor on document. On the Vidami Blue, HOLD Speed and Forward as you TAP Play/Pause. The blue LED will blink 3 times and the name of the current mode will print out on your document.

PRO TOOLS TRACK & PREFERENCE SETUP

In order to optimize the use of your Vidami Blue, the following settings need to be configured.
Track Setup
Under the Track menu, select Duplicate to open the Duplicate Tracks dialog box. In the Duplicate Tracks box: de-select Active Playlist, Alternate Playlist, and Automation. Click “OK” to save. (Navigation:
Track menu/Duplicate/Duplicate Tracks)
Preferences Setup
Under the Pro Tools menu, select Preferences / Operation. Under the Record quadrant: use the drop-down menu next to Record Enable Buttons, and select Cancel Previous on All Tracks.
Click “OK” to save.
(Navigation: Pro Tools menu/Preferences/Operation/Record/Record Enable Buttons)
Edit Window Setup
In the upper left corner of the Main Edit Window, beneath the Tool Bar, there are a series of buttons depending on your version of Pro Tools, there may be up to seven.    Configure these buttons as follows:

• Tab to Transients > Active
• Link Timeline and Edit Selection > Active
• Link track and Edit Selection > Active
• Insert Follows Playback > Inactive
• Automation Follows Edit > Active
• Mirrored MIDI Editing > Inactive
• Layered Editing > Inactive

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>