KONIYCOI NK6 TWS Wireless Earbuds User Manual
- June 12, 2024
- KONIYCOI
Table of Contents
Face The World And Say: I Have My Strength!
TWS earbuds **Manual**
ENJOY MUSIC COMFORTABLY
- Please follow the suggestions of audiologist. Do not listen to music at high/max volume, do not use earphone for a long time
- If the sound is too piercing, please turn down the volume or stop using the earbuds.
CHARGING
Charge the charging case with Type-C cable
- Charge the charging case via an adaptor or a working computer through it’s USB port.
- when charging, the red LED light indicator of the charging case blinks
- When charging is completed, all LED light indicators of the charging case turns on without blinking.
- Charge the earphones with the case @Put the earphones in correct slot and close the charging case, the earphones will be charged automatically and light indicator turns red ©When earphones charging is completed, earphone light indicator is off
PAIRING
- Make sure the earphones and your wireless device are next to each other ( within 1 meter)
- Take out the earbuds from charging case, they will automatically power on and paired, the earphone light indicator flash red and blue alternately
- Activate the bluetooth function on your phone and search for device name NK6
- Once connected, the earphone red light will flash slowly.
PRODUCT MANUAL
PARAMETER
model: …………………………………………………………………….NK6
Wireless: ……………………………………………………………………….V5.3
Music time (earphone full power state): ……………………………………………..4-6hrs
Music time (earphone full power + charging box full power condition):
…………………………………… 25-30hrs
Charging box battery capacity: ……………………………………………………….. 400mAh
Trumpet impedance: ……………………………………………………………..16Ω
Headset charging time: ………………………………………………..1.5h
Enter : …………………………………………………………………….5V 0.5A
Headphone battery capacity (single): ……………………………………………… 40mAh
Standby time: ………………………………………………………………..230hrs
Charging port: ………………………………………………………………. Type – C
Support: ………………………………………… HSP\HFP\A2DP\AVRCP
BUTTON CONTROL
Function | Operation |
---|---|
Power on/off | Take out from/put in the charging case |
Pairing Mode | Automatically pairing when taken out from charging case |
Play/Pause | Short touch left/right side |
Next song | Touch the right side 2 times |
Previous song | Touch the left side 2 times |
Volume+ | Touch the right side 3 times |
Volume- | Touch the left side 3 times |
Answer phone Call/ Hang up | Short touch left/right side |
SIRI | Long touch on left/right side,until hearing the ‘beep’tone |
LED Indicator | Status |
--- | --- |
Red light flashes quickly | In pairing mode |
Red light flashes slowly | Paired with a wireless device |
Red light flashes quickly | Power on |
Red light on | Power off |
Light off | Charging complete |
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.