JFA Electronics K1200 JFA Control Distance Remote Control Owner’s Manual

JFA Electronics K1200 JFA Control Distance Remote Control Owner’s Manual

DESCRIPTION

The K1200 allows you to control by distance’ the main functions of the “player” and change music, folder, volume, pause, play and power.

OPERATION

Transmitter unit: whenever you press a key, the blue LED will light up, indicating transmission.
Receptor unit: the “led action” will turn on indicating the presence of a received signal.

NOTE

• The central will not work if the coding procedure is not performed.
• Check the light intensity of the transmitting unit LED. If it is weak or does not light, replace the battery.

‘For a longer range, install the equipment in a location where the antenna is free and the most exposed as possible, the distance achieved is 1200 meters in open area.

INDICATIONS AND BASIC COMMANDS

Transmitter unit:

1. Volume control;
2. Music Change;
3. Folder Change;
4. Play / Pause;
5. Power / Function (changes to AUX, CD, USB, radio, etc.).

Receptor unit:

1. RF receptor antenna;
2. Led action, indicator of reception;
3. Code IR (see learning mode);
4. Power 12V (black white stripe) and GND (black).
5. infra-red emitting (point to the front of the player);

ENCODING THE CONTROL

LEARN MODE:
(Learning the functions of the original control)

1. Press the “A” key (note 1) the Led action will be constantly on;
2. Press the key of the k1200 Control (note 2),that you want to record until the “Led action” stay flashing;
3. Point the original player control to the IR code entry and press the key you want to record (note 4) until the LED action flashes quickly, and then be constantly on;
4. Repeat steps 2 and 3 for the other keys;
5. After finishing this process press the key “A” (Note 1) of the receptor or wait 10 seconds to exit the mode.

MEMORY MODE:
(The receptor has stored in its memory codes the main models of “player” (see the attached index or on the website:
www.jfaeletronicos.com)).

1. Press the “M” key (Note 3), the LED action will be constantly on;
2. Press the key on the control (note. 2) corresponding to the model of the “player”, as the index, for example: to program the CD SONY, you should perform step 1, then press the keys in sequence, in the control . Check that the LED will flash one time and then 4 times, indicating that was programmed the model 14 (Sony).
3. After finishing this process press the key “M” (note 3) of receptor or wait 10 seconds to exit the mode.
   

INDEX 01 – oF MEMORY MODE ENCODING

Observation: keys to be pressed simultaneously (& ») (4+—)

RECOMMENDED INSTALLATION

RECOMMENDATIONS AND NOTES

1. Install the receptor unit at least 1 meter of the Alarms central or electronic injection module. It is recommended to install receptor in the trunk and the infrared emitting in the rear seat pointing to the front of the “CD player”.
2. For greater range should keep the antenna stretched and in a location that is visual and away from the car bodywork.
3. supply the receiving unit with 12V.
4. The receptor can operate with two transmitters; for this, performing steps 1 and 2 to the new transmitter. This feature is recommended for customers using the Slim control on the steering wheel and a K1200 to control by distance from the player.

TECHNICAL CHARACTERISTICS

Homologated product

“This equipment operates on a secondary basis,have not the right of protection against armful interference, ‘ even of the same type of station, and ANATEL notmay cause interference to systems operating in primary basis. ”

See all products of the automotive line on our website.
www.jfaeletronicos.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>