BadZwo Baader Steeltrack Zwo EAF Halter Bracket Instruction Manual
- June 13, 2024
- BadZwo
Table of Contents
BadZwo Baader Steeltrack Zwo EAF Halter Bracket
Product Information
Product Name: BadZwo – Baader Steeltrack Zwo EAF Halter/Bracket
Product Usage Instructions
- Mount the 5 to 7mm flexible coupling with two set screws. Make sure not to tighten this one.
- Turn the motor into the correct position by using the focuser knob on the right side.
- Push the bracket a little bit against the motor and tighten (with a bit of force!) the three M6 screws including washers.
- Use the M4 screws (Orig. EAF) including washers to tighten the motor (with a bit of force!).
- The assembly is now complete.
Installation instructions
- Remove the three slotted set screws; Remove the thumb screw; Remove the focuser knob on the left side (two set screws 90° position)
- Mount the 5 to 7mm flexible coupling with two set screws
- Mount the bracket with M6 screws and washers (do not tighten) incl. the thumb screw (do not tighten this one)
- Mount the motor with the flexible coupling (two set screws 90° position), use the focuser knob on the right side to turn the motor, if necessary
- Turn the motor into the correct position while using the focuser knob on the right side
- Push the bracket a little bit against the motor and tighten (a bit of force!) the three M6 screws incl. washers; Use the M4 screws (Orig. EAF) incl. washers to tighten the motor (a bit of force!)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>