CircuPool CIR-T3 CIR-T-Series Replacement Cell User Guide
- June 13, 2024
- CircuPool
Table of Contents
Replacement Cell compatible with Hayward®
Aqua Rite® Turbo® T-Cell®
User Guide Models: CIR-T3, CIR-T9, CIR-T15
CIR-T3 CIR-T-Series Replacement Cell
Includes: | Replacement salt cell (w/cable) only |
---|---|
Cable Length: | 15’ (nominal) |
Compatibility: | Hayward® Goldline® Aqua Rite®, AquaLogic®, Pro Logic®, |
SwimPure®, Mineral Springs®, NatureSoft®, AquaPlus®, LeverEdge Guardian®, Blue Essence®, SplashClear® and more
Congratulations on your purchase of a new CircuPool CIR-T-Series Replacement
Cell!
Please take a moment to familiarize yourself with your equipment and this User
Guide.
This Cell was designed to meet or exceed original specifications, for optimal
performance and reliability. Be sure to read and follow all instructions from
your original salt chlorine generator system.
CELL INSTALLATION
-
IMPORTANT: Always make sure the input power is completely disconnected and all pool equipment is shut off before attempting any service procedures. All service should be performed by a qualified professional.
-
IMPORTANT: Before installing your new cell, make sure that pool’s salinity is between 2700-3400ppm.
-
Remove the old Cell from the plumbing by loosening the threaded collars on both ends of the Cell. Disconnect the Cell Cord from the control panel.
-
Inspect the O-Rings on the plumbing unions. If damaged or worn, replace before installing the new Cell.
-
Position the new CircuPool T-Series Replacement Cell between the plumbing unions. The cell is not directional.
Tighten the two threaded collars by hand for a water-tight seal, do not over- tighten. Plug the Cell Cord into the control panel. -
Once power is restored to the control panel (concurrently with the pump and filter), the system can now be operated as instructed in the original manufacturer’s product manual.
NOTE: If your control panel was previously reading incorrectly salt
levels, it should recalibrate within 24-48 hours.
NOTE: If you are replacing the same size cell, there are no software
compatibility issues. If you are using the CircuPool T-15 to replace a smaller
size cell (T-9 or T-3, for example), be sure to change the “Cell Type” setting
on your original electronic controls to match (only control units made after
2009 with firmware 1.5 or later have this ability). Please see the electronic
controls original manufacturer’s product manual for specific instructions.
MAINTENANCE
The CircuPool Replacement Cell operates in the same way as your original Cell.
As with your prior system, it may occasionally be necessary to remove the
mineral deposits which can form inside. Cleaning frequency is entirely
dependent on your pool’s water chemistry, which depending on environment and
chemicals added, can change to become more or less scale forming. Follow the
cleaning instructions in the original manufacturer’s product manual, or visit
www.circupool.com/help for more
recommendations.
Please note CircuPool is not affiliated with Hayward Industries, Inc. The use
of such trademarks herein is for informational purposes only, and the
product(s) are not those of Hayward Industries Inc., but rather are simply
compatible with the referenced Hayward product.
CIRCUPOOL LIMITED WARRANTY
CircuPool CIR-T-Series Replacement Cells carry the following Limited
Warranty should failure occur due to faulty manufacture or materials, during
normal use and service. For residential use, the manufacturer warrants to the
original purchaser that the equipment shall be free of manufacturer’s defects
at the time of sale, and upon examination shall provide replacement parts in
accordance with the following schedule:
Year One – No charge for parts.
Year Two – No charge for parts.
Year Three – Parts supplied at 2/3 of base price.
For Commercial use (any pool that is not for private single-family use, or the
use of which is subject to regulation), parts are warranted against defect for
a period of one year.
This limited warranty is subject to the following terms, conditions, and
exclusions:
-
To obtain the benefits of this warranty, contact the warranty department for troubleshooting. You may obtain current contact information at www.circupool.com/help. Warranty claims must be initiated in a timely manner. Upon discovery of a defect, the warranty department will issue a Return Merchandise Authorization (RMA) and defective items and parts are to be shipped by customer to an authorized service representative, freight prepaid.
Upon examination, the determination of the cause of failure shall be made solely by CircuPool Products. The date upon which the claim is submitted, and an RMA is issued shall solely serve to determine at what point the claim falls within the schedule of warranty proration, in comparison with the original purchase date. No packages will be accepted without a RMA number. -
Should a defect in any item or part covered by the warranty become evident during the warranty’s term, CircuPool Products will at its sole discretion repair or replace such item or part. CircuPool Products reserves the right to replace defective parts with new or refurbished parts. This warranty does not include the cost of labor or transportation charges for equipment or component parts to or from CircuPool Products, or the removal, reinstallation, or any such costs incurred in obtaining warranty replacements or repair.
-
This warranty extends to the original retail purchaser and original installation site only, beginning at the original date of purchase, and is non-transferrable.
-
The warranty contains the following exclusions. O-Rings, rubber gaskets and seals, electrical fuses, and circuit-breaker components are normal replacement items subject to wear and are excluded from the warranty. Product discoloration, or any other cosmetic or superficial damage or deterioration, regardless of its cause, is not covered by this warranty. The warranty is not applicable to problems arising from circumstances outside the control of CircuPool Products, including, but not limited to the following:
A. Damage or premature wear due to improper pool chemistry, and failure to maintain pool water chemistry in accordance with the recommendations contained in the owner’s manual.
B. Damage due to improper installation or connection to improper voltages, including materials and workmanship supplied by others.
C. Damage due to negligence or failure to properly maintain equipment, including operation with insufficient water flow or the maintenance of clean and tight electrical connections.
D. Damage due to improper service, as well as unauthorized equipment modifications and use of non-genuine replacement parts.
E. Damage due to misapplication, misuse, abuse, or failure to operate equipment as specified in the owner’s manual.
F. Problems resulting from tampering, accident, fire, flood, freezing, lightning, insects, or other natural elements, or other circumstances beyond the control of CircuPool Products.
G. Damage due to over-tightening of threaded components or excessive pressure or stress.
The liability of CircuPool Products shall not exceed the repair or replacement
of defective items or parts under the referenced limited warranty terms. There
are no implied warranties of merchantability or fitness for a particular
purpose that apply to this equipment. Under no circumstances shall CircuPool
Products, its agents, employees, and affiliates be liable for any loss,
damage, injury, inconvenience or loss of time, incidental expenses such as
labor and material charges, or any other incidental, or consequential damages,
which may result from the use, installation, removal, or reinstallation of its
equipment and parts.
This warranty is valid only in the United States of America. This warranty
gives you specific legal rights and you may also have other rights, which vary
from state to state. This warranty supersedes all previous publications. Any
dispute between the original purchaser and CircuPool Products will be settled
by binding arbitration, conducted in Harris County, Texas, under the rules of
the American Arbitration Association.
CircuPool Products (888)-206-9938
www.circupool.com/help