The BRICK OSCESDSK-202704 Oscar Reversible Desk Instruction Manual

The BRICK OSCESDSK-202704 Oscar Reversible Desk

Product Information

The product is identified as OSCESDSK/202704 and is an assembly kit. It includes various parts and hardware for the assembly process. Glue is recommended for use in securing wood dowels.

Product Usage Instructions

1. Glue not included. It is recommended to apply some glue into holes before inserting wood dowels.
2. Screw in the cam post and tighten it in place.
3. Ensure that the cam lock arrow is pointed to the hole. Align the cam lock screw to the hole of the cam lock case.
4. After turning the cam lock case to the locked position, the cam lock arrow will be located in the position shown above.
5. Follow the step-by-step assembly instructions provided in the manual, using the identified parts and hardware.
6. Refer to the labeled diagrams for each step to ensure correct placement and alignment of the parts.
7. Pay attention to any additional instructions or warnings provided in the manual to ensure safe and proper assembly.
8. Once assembly is complete, secure the product using the anti-tipping strap according to the provided instructions.

Necessary tools

Glue not included ( We recommend to apply some glue into holes before inserting wood dowels .)

How to use cam lock system **

**

*Ensure that the cam lock arrow is pointed to the hole, align the cam lock screw to the hole of the cam lock case.

*Use a straight edge screwdriver to turn cam lock case until it is locked.Locked position is approximately 1/2 turn(210°) clock-wise.

*After turnning the cam lock case to the locked position,the cam lock arrow will be located in the position shown above.

PARTS IDENTIFICATIONS

1. 1pc/pce
2. 1pc/pce
3. 1pc/pce
4. 1pc/pce
5. 1pc/pce
6. 1pc/pce
7. 1pc/pce
8. 1pc/pce
9. 1pc/pce
10. 1pc/pce
11. 1pc/pce
12. 1pc/pce
13. 1pc/pce
14. 2pcs/pces
15. 2pcs/pces
16. 2pcs/pces
17. 2pcs/pces
18. 2pcs/pces
19. 2pcs/pces
20. 1pc/pce
21. 1pc/pce
22. 1pc/pce

HARDWARE IDENTIFICATIONS

ASSEMBLY INSTRUCTIONS

ANTI-TIPPING STRAP INSTRUCTION

DRYWALL ANCHOR $8X40 X 1PCS
Fixation en métal 12X12X1 X 2PCS
Vis $5X40 X 1PCS
Sangle 197X5X1 X 1PCS
Vis $4X25 X 1PCS

DRILL & DRILL BIT
LIGHT HAMMER

1. Find spot on wall l” below the top of item

2. Using a drill bit slightly smaller than the gauge of anchor , drill a hole, then place the anchor into wall.

3. Screw the metal bracket into the anchor of wall.

4. Screw the second metal bracket into the back of item along the of soleid frame.

5. Insert strap thru the bracket attached to wall and the second attached to the product.

6. Pull tightly: Et puis tirer fermement.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>