DREAM LINE BTNL5928FFXIC00 Nile 59 in. L Acrylic Flatbottom Bathtub Installation Guide
- June 4, 2024
- DREAM LINE
Table of Contents
DREAM LINE BTNL5928FFXIC00 Nile 59 in. L Acrylic Flatbottom Bathtub
CAUTION
- Carefully read the instructions before starting the installation.
- This bathtub should be installed by an experienced plumber.
- You will need at least two people to install this product properly.
- In order to reduce the risks of personal injuries, do not support or lift the bathtub by the rim. Provide adequate support under the feet.
- DreamLine® is not responsible for any damage to the unit or personal property caused by improper installation. If you disregard instructional warnings, you will void your warranty.
- Unpack and inspect the bathtub for damage. Return the bathtub to the carton until you are ready to install.
- Install the bathtub on an adequately supported, level floor.
- Before installation, ensure proper access to the final plumbing connection.
- Drain waste vent must always be installed according to local standard. Verify the placement of the bathtub before drilling the hole for the drain waste vent.
INSTALLATION MANUAL
-
Remove the bathtub from its carton and place it on a throw rug or other protective floor covering material to prevent damage to the bathtub or floor.
-
Position the tub in its final location and trace its outline with a pencil.
-
Position a clean drop cloth or similar material in the bottom of the bathtub. Be careful not to scratch the surface of the bathtub.
-
Level the bath by turning the leveling feet at the bottom of the tub. (You will need two people to manage this task).
-
If drain waste vent is not directly below the drain please use an adjustable flex pipe (not included) and follow steps 6-10 otherwise if not please continue down to straight drain installation steps 11.
USING FLEX PIPE -
Place tub on its side and connect flex pipe to the tub drain pipe using the lock nut connector.
-
Arrange the flex pipe and connect its end to the waste vent. (use PVC cement to connect)
-
Flip over the bathtub.
-
Fill the bathtub to the overflow and check for leaks.
-
Affix the bathtub by applying silicone on the contour of the base. Let dry 24h.
STRAIGHT DRAIN INSTALLATION (NOT INCLUDED)
(Requires a Quick Connect Drain *sold separately OR access below the floor, OR must be built on a platform)
-
Connect the drain directly to the drain waste vent. (Straight drain tail piece not included).
-
. Flip over the bathtub.
-
Fill the bathtub to the overflow and check for leaks.
-
Affix the bathtub by applying silicone on the contour of the base. Let dry 24hr.