ADMIRAL Vintage Luminaire 60W Seetronic True Luminaire User Manual
- June 12, 2024
- ADMIRAL
Table of Contents
ADMIRAL Vintage Luminaire 60W Seetronic True Luminaire
Product Information
The Vintage Luminaire 60W Seetronic True is a lighting fixture designed for indoor use only. It is CE-marked, indicating compliance with European safety standards. The luminaire has an input voltage of 230V and operates at 50Hz. It uses an E27 lamp with a maximum wattage of 60W. The product is manufactured by Admiral Staging in the Netherlands.
Product Usage Instructions
Lamp Replacement:
- Step 1: Remove the snoot and deflector from the luminaire.
- Step 2: Replace the lamp with a new one.
- Step 3: Replace the snoot and deflector back onto the luminaire.
Maintenance
To clean the Vintage Luminaire, use a cloth and a soft detergent. Avoid using aggressive cleaning agents, solvents, or corrosive substances. After cleaning, dry the product with a soft cloth. Regularly check the luminaire for dirt, damages, loss, and corrosion. If any components are missing or worn out, immediately take the product out of service and consult your supplier for advice. Only qualified personnel should perform repairs or maintenance on the luminaire.
Assembly
The luminaire can be assembled in different configurations:
- Single Bracket: Use the provided 5 mm ring for assembly.
- Double Bracket: Use the provided 5 mm ring and 2 mm ring for assembly.
- Bracket Use as Floorstand: Use the provided 2 mm ring for assembly.
- As Hanging Bracket: Follow the appropriate hanging instructions.
- For Storage: Adjust the luminaire as needed for storage purposes.
Please refer to the user manual or consult your supplier for detailed instructions on each assembly configuration.
For further assistance, please contact Admiral Staging:
- Website: www.admiralstaging.com.
- Phone: +31 534 301 201
LAMP REPLACEMENT
- Step 1 remove snoot and deflector
- Step 2 replace lamp
- Step 3 replace snoot and deflector
MAINTENANCE
Clean the Vintage luminaire with a cloth and a soft detergent. Please do not use aggressive cleaning agents such as solventsand/or corrosive substances. After cleaning the product, dry it with a soft cloth. For safety reasons, the product must be checked regularly for dirt, damages, loss and corrosion. By wear and or mis-sing of the proper components this product should be immediately taken out of service. Consult your supplier for advise.Repair / maintenance is only permitted by a qualified person. In case of doubt, consult your supplier.
ASSEMBLY
BRACKET USE
AS FLOOR STAND
AS HANGING BRACKET FOR STORAGE Designed for indoor use only Do not dispose in the general waste CE marked Admiral Staging the Netherlands www.admiralstaging.com. +31 534 301 201
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>