Zalerock WTHG002 Single Handle Pull Down Sprayer Kitchen Instruction Manual

Table of Contents

Manual

Cleaning
Before installation, shut off the water supply valves and clean up the water supply system.
Mounting hole
Make sure the mounting hole size is between 033mm-035mm as shown in the diagram.
Protection
Clean the area of the mounting holes before installation. To preserve the delicate finish of the faucet, please. Do not scratch, but use a soft cloth to wipe around it.
Do not tighten the faucet too hard, so as to avoid deformation or fracture.

The kitchen faucet is suitable for one-hole or three-hole installation. For 3-holes installation, pass the faucet base and deck plate through the flexible hose according to the order in diagram 1.
Pass the rubber ring, metal gasket, and mounting nut through the flexible hose in the order shown in diagram 2, then tighten the mounting nut clockwise by hand.
Use a phillips screwdriver to tighten the 2 screws, as shown in diagram 3.
Connect the hot and cold inlet hoses onto the matching water valves and secure them properly, as shown in diagram 4.
After the installation is complete, tum on the faucet and run for few minutes to check for leaks.

Operate the faucet gently in order for a sustainable use.
Always blot dry any water from faucet surface Clean with a damp non-abrasive sponge and wipe it with a clean soft cloth should be helpful to maintain good finish of the faucet.
To remove water spots, please apply warm water and a damp soft cloth. Make certain to rinse thoroughly with wate immediately after cleaner.
Although the fin ish is extremely durable, it can be damaged by some cleaners. Do not use detergent powder, polishing powder, granular detergent or nylon brush to clean.
Do not use acidic detergents. If happened, it must be rinsed properly and wiped dry with a soft cloth.
When the air temperature is below O ·c, a measure should be taken to keep the faucet working condition warm.
Shut off the water supply valves when the faucet will not be in use for an extended amount of time.
Do not allow the product to get in touch with the rust or strong corrosive substances, or install under a corrosive environment

Constant water sensor:Wave your hand in front of the upper sensor area, the faucet will water on automatically, and wave again to water off.
Instant water sensor:Move your hand under the bottom sensor area, the faucet will water on automatically, and move your hand away the faucet will water off automatically.
Time-up protection:The spray head will stops automatically when continuous running water exceed 3 minutes to avoid users forget to turn off the fa ucet.

Charging: Before charging the spray head , please turn off the faucet handle and remove the spray head first, then dry with tissues and open the rubber USS cover on the spray head to charge. (The indicator light will be lighted during charging and off after fully charged. Unpluged the cable power from spray head can be used after 5 seconds.
a.The indicator light continuous flashing 5 times slowly means the power is low and need be recharged.
b.The indicator light continuous flashing fast and do not work mean that the power runs out and need to recharge immediately.
. For long-term non-use of the spray, please store it in dry area and recharge every 6 months to optimize product lifetime.
To clean the filter grid, please turn off the faucet handle first and remove the spray head, then take out the filer grid to clean it up and assemble it back.
Please use the clean and soft cloth to wipe the spray head surface.(strong detergents are not allowed to use on product).

Read User Manual Online (PDF format)