PORT CONNECT 901603 Stereo Headset with Microphone User Manual
- June 4, 2024
- PORT CONNECT
Table of Contents
USER MANUAL
STEREO HEADSET
WITH MICROPHONE
REF : 901603
TECHNICAL SPECIFICATIONS
CONNECT: 3,5 mm 4 pin jack (combo jack)
HEADSET
- Driver : Ø27 mm Dynamic type
- Nominal impedance : 32ohm ± 5%
- Frequency response : 20Hz ~ 20KHz
- Max input power : 20mW
MICRO
- • Sensitivity : 98 ± 3 dB/mW
All trademarks and registered trademarks are the property of their respective owners.
PRODUCT
STEREO HEADSET WITH MICROPHONE
INSTRUCTIONS
Plug the audio headset jack to the audio jack output of your device
WARNING
Keep away from water, fire, liquids and out of the reach of children.
Avoid exposing the product to prolonged periods of extreme heat or cold.
Qualified personnel must replace the product to avoid a hazard. Do not
dismantle or attempt to repair this product yourself.
TROUBLESHOOTING
If the unit appears to have failed in functioning, please check the following:
Check that the jacks are correctly plugged to your device on the appropriate
jack plug (audio & microphone)
If no sounds come from the headset, check that volume level of the remote is
not on minimum then check that the sound setting of your device is not
disabled or set a minimal value.
If the microphone does not work, check that the microphone remote switch is
activated. Check that the microphone settings of your device are correctly
configured.
PRODUCT REGISTRATION
PORT EUROPE recommends that you register your product shortly after its purchase on the website http://www.port-connect.com
TECHNICAL SUPPORT
For technical questions regarding your product, please go to the contact/support section on the website http://www.port-connect.com
DECLARATION OF CONFORMITY
This declaration of conformity is issued under the sole responsibility of the
manufacturer.
Hereby, PORT EUROPE, 22 rue de la Fédération 75015 PARIS France, declare that
this product complies with the essential CE requirements and provision and is
in accordance with the standards, guidelines and specifications mentioned
below:
EMC Directive 2014/30/EU
EN 55032:2015+AC:016 Class B
IEC 61000-3-2:2014
IEC 61000-3-3:2013
EN 55035:2017
IEC 61000-4-2:2008
IEC 61000-4-3:2006+A1:2007+A2:2010
IEC 61000-4-8:2009
RoHS Directive 2011/65/EU – A2 2015/863/EU
Eric RAMPI
04/03/2022, Paris
EUROPEAN DIRECTIVE 2012/19/EU
The European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal household waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The symbol of the crossed out dustbin is marked on all products to remind the obligations of separate collection. Consumers should contact their local authority or retailer for information concerning the correct disposal of their product.