MikroElektronika Si4703 mikroBus Click Board User Guide
- June 12, 2024
- MikroElektronika
Table of Contents
Si4703 micro Bus Click Board
User Guide
Introduction
FM Click™ is an accessory board in micro BUS™ form factor. It’s a compact and
easy solution for adding broadcast FM radio tuner to your design. It features
Si4703 FM radio tuner, two LM4864 audio amplifiers as well as stereo audio
connector. FM Click™
communicates with the target board microcontroller via micro BUS™ 2 I C (SDA,
SCL), INT, RST, CS and AN lines. The board is designed to use 3.3V power
supply only. LED diode (GREEN) indicates the presence of power supply.
Downloaded from Arrow.com.
Soldering the headers
- Before using your click board™, make sure to solder 1×8 male headers to both left and right side of the board. Two 1×8 male headers are included with the board in the package.
- Turn the board upside down so that bottom side is facing you upwards. Place shorter parts of the header pins in both soldering pad locations.
- Turn the board upward again. Make sure to align the headers so that they are perpendicular to the board, then solder the pins carefully.
Plugging the board in
Once you have soldered the headers your board is ready to be placed into desired micro BUS™ socket. Make sure to align the cut in the lower-right part of the board with the markings on the silkscreen at the micro BUS™ socket. If all of the pins are aligned correctly, push the board all the way into the socket.
Essential features
FM Click™ with it’s Si4703 IC is a complete FM radio tuner (from antenna input
to stereo audio output). It supports worldwide FM band (76 – 108 MHz). The
board contains automatic frequency and gain control, RDS/ RBDS processor, seek
tuning and volume
control. All these features make this board ideal for MP3 players, portable
radios, PDAs, notebook PCs, portable navigations and many more.
FM Click™ Board Schematic
Earphones and antenna
FM antenna is provided through the earphones cable (recommended length between 1.1 and 1.45 m). The board supports 3 and 4 conductor earphones with pinout as shown in schematic. Earphones are not included in the package
Code Examples
Once you have done all the necessary preparations, it’s time to get your click board up and running. We have provided the examples for micro, micro Basic and micro Pascal compilers on our Linstock website. Just download them and you are ready to start.
Support
Microelectronic offers Free Tech Support (www.mikroe.com/esupport) until the end of product lifetime, so if something goes wrong, we are ready and willing to help!
Micro Electronica assumes no responsibility or
liability for any errors or inaccuracies that may appear in the present
document.
Specification and information contained in the present schematic are subject
to change at any time without notice.
Copyright © 2013 Micro Electronica. All rights reserved.
Downloaded from Arrow.com.
www.mikroe.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>