TOYOTA Digital Om Format Parking Sensor Innova Zenix Owner’s Manual
- June 12, 2024
- Toyota
Table of Contents
INNOVA – MAY – 2023 – 001
PARKING SENSOR
OWNERS MANUAL
Please read this manual for proper operation and keep it for future reference.
SECTION 1.0 Introduction
1.1 Operating Instructions
- This Toyota Innova is equipped with a system that facilitates parking manoeuvres in reverse and forward by detecting any obstacles that could damage the car.
- This system is equipped with two audible warning device which produce low pitch acoustic for front detection and high pitch for rear detection.
- Any obstacle detected is indicated by an intermittent beep signal, which increases in frequency until it becomes a continuous beep as the vehicle moves near to the obstacle itself.
Note:
When the gear is at “P” or “N” position, front sensor is also activated except
parking brake is “ON”.
SECTION 2.0 User Instructions
2.1 System Operating Condition
CONDITIONS| FRONT SENSOR REAR SENSOR|
---|---|---
MAIN SWITCH (LED)| GEAR POSITION| PARKING BRAKE /SPEED
ON (LED ON)| Reverse (R)| Parking Brake OFF & vehicle speed less than approx.
15km/h| ON| ON
Parking Brake ON or vehicle speed more than or equal to approx. 15km/h| OFF|
ON
Except
Reverse (R)| Parking Brake OFF & vehicle speed less than approx. 15km/h| ON|
OFF
Parking Brake ON or vehicle speed more than or equal to approx. 15km/h| OFF|
OFF
OFF (LED OFF)| Reverse (R)| All Mode| OFF| ON
Except
Reverse (R)| All Mode| OFF| OFF
- Parking Brake and Speed are only applicable to Front Sensor.
2.1 System Operating Condition
Note:
- LED in main switch turns “ON” and “OFF” alternatively by pushing the main switch button.
- When the main switch button is pushed “ON” side, LED in the switch turns “ON”, and front speaker makes a distinct pattern of beep sound depending on which front sensor is disconnected. Refer Table 1 below for more detail.
- When the gear is shifted to reverse, rear speaker makes a distinct pattern of beep sound depending on which rear sensor is disconnected. Refer Table 1 below for more detail.
Table 1: Sensor Diagnostic Alert Pattern
| SENSOR | ALERT PATTERN |
|---|
Left Sensor
Disconnected| Speaker emit a single short beep followed by 5 repeated single
beep
Right Sensor Disconnected| Speaker emit a single short beep followed by 5
repeated two single beep
Left & Right Sensor Disconnected| Speaker emit a single short beep followed by
5 repeated three single beep
No Sensor Disconnected| Speaker emit a single short beep
22 Detection Zone
| Sensor / Detection | Front | Rear | BEEP SIGNAL |
|---|---|---|---|
| FL, FR | RL, RR | ||
| Zone 1 | Approx. 0.00 | ||
| to 0.45m | Approx. 0.00 | ||
| to 0.51m | The buzzer gives continuous beep if an obstacle is detected. | ||
| Zone 2 | Approx. 0.45 | ||
| to 0.68m | Approx. 0.51 | ||
| to 0.76m | The buzzer gives intermittent beep (8 beeps / sec) if an obstacle is |
detected.
Zone 3| Approx. 0.68
to 0.91m| Approx. 0.76
to 1.67m| The buzzer gives intermittent beep (5 beeps / sec) if an obstacle is
detected.
2.3 General Recommendation
- This device is a parking aid but the driver must ultimately be responsible for evaluating obstacles.
- High speed manoeuvres using this device may prevents the obstacles from being detected in time.
- In certain circumstances, awkward obstacles, such as very low, thin, small or pointed ones may not be detected.
- To avoid faulty operation, mud and dirt must be cleaned from the sensors. Do not use hard or pointed objects to clean the sensors.
- Objects directly underneath the bumpers cannot be detected. Some objects located lower than the ultrasonic sensors, or thin objects, may not be detected as the vehicle comes close to these objects.
- Objects might not be detected if the vehicle is too close.
SECTION 3.0 Warranty Conditions
3.1 Warranty
- Warranty coverage is limited to the use of the system. Damage caused by collisions due to incorrect signals, (or lack of signals), improper use of the warmning signal or driving errors are excluded from the warranty.
- The product is covered as per your vehicle warranty terms and conditions.
- The warranty shall not apply if the product has been damaged due to be any other causes other than those described as manufacturing defects.
- Refer any matters relating to this warranty to your authorized dealer / service branch.
3.2 Customer Care
For further information on the system, please contact your nearest UMW Toyota
Motor Service Branch or:
CUSTOMER RELATIONS MANAGEMENT (CRM)
No. 2, Persiaran Raja Muda, Section 15,
40200 Shah Alam, Selangor Darul Ehsan.
Toyota Freephone : 1800-8-TOYOTA (869682)
Operating Hours : 8.00 am – 5.30 pm (Monday to Friday)
Website : www.toyota.com.my
Email : customersupport@toyota.com.my