VADO WG-095S-C Short Concealed Cistern Instruction Manual
- June 12, 2024
- VADO
Table of Contents
where inspiration flows
WATERGAMES
Installation Guide
Short
frameless wall hung cistern
WG-095S-C
Keep for future reference
Important – please read
VADO reserves the right to make technical improvements and enhance the
appearance of the products included in this instruction manual.
Please read these instructions carefully before starting installation and keep
for future reference.
Remove all packaging and check the product for missing parts or damage before
starting installation.
Any alterations made to this product and fittings may infringe water
regulations and will invalidate the guarantee.
The installation must comply with all Local/National Water Supply Authority
Regulations/ Byelaws and Building and Plumbing Regulations.
To be installed in accordance with BS EN806.
We strongly recommend that you use a qualified and registered plumber.
General Care and Safety
Wall plugs supplied are ONLY suitable for solid stone/brick walls. They are
not suitable for use in aerated blocks or similar. If fixing to a stud wall,
sufficient extra internal reinforcements must be made to the wall. Screws must
locate into suitably reinforced studs and noggins.
Take care using power tools – The use of a residual current device (RCD) is
recommended.
Beware of hidden cables or pipes when drilling.
This product can be dangerous if installed incorrectly. This product must be
installed by a qualified plumber or installer. It is the installer’s
responsibility to check that the fixings are suitable for the installation in
hand.
Cistern fittings are suitable for Water pressure: 0.2 – 10 bar. Do not add
caustic chemical substances (eg containing chlorine compounds or similar into
the cistern. These can damage the valve components and cause failure.
Before starting to enclose the frame, the system must be first tested for
leaks before 2nd fix commences. Using the help of a second person to hold the
pan in place on the frame, turn on the water supply and flush the pan to check
for leaks.
When installed, the fitting must comply with the requirements of the Water
Supply (Water Fittings) Regulations 1999 and Scottish Byelaws 2004.
For further information, contact the Water Regulations department of your
local water supplier (see the WRAS website www.wras.co.uk for details) or the
Water Regulations Advisory Scheme by email (info@wras.co.uk) or telephone:
01495848454.
Please take great care when installing this product not to damage its surface.
Please note if installing in an enclosed environment, access should be left
for servicing and maintenance. No costs relating to inadequate access can be
accepted.
Further information
For instructions on how to side-mount the product, spares and guarantee
information please visit our website at
https://www.vado.com/sites/default/files/flush-cisterns- install-
instructions.pdf or by scanning the QR code:
Dimensions – toilet connection
Dimensions
Installation
Installation for top plate
 Installation – toilet
connection
Flow Adjustment (6/3
Litres — > 4/2.6 Litres)
Parts list:
| Item | Part | Code | Oty |
|---|---|---|---|
| 1 | Faceplate bracket | WG-095-02 | 1 |
| 2 | Short access install box | WG-095-07 | 1 |
| 3 | Install box screw set | WG-095-08 | 1 |
| 4 | Flush pipe | WG-095-09 | 1 |
| 5 | Short flush bend pipe | WG-095-11 | 1 |
| 6 | Twist 1/2 female x 1/2 female 167mm | ||
| anti-corrosion hose | T-1/2X1/2-AC167K-TWT | 1 | |
| 7 | Short flush valve bracket 1 | WG-095-13 | |
| 8 | Short flush valve bracket 2 | WG-095-15 | |
| 9 | Short inlet connection with filter & | ||
| ball valve | WG-095-17 | ||
| 10 | Plate connecting rods | WG-095-18 | 1 |
| 11 | Short flush valve base | WG-095-20 | 1 |
| 12 | Short flush valve | WG-095-22 | 1 |
| 13 | Short Flush valve gasket | WG-095-24 | 1 |
| 14 | Short inlet bracket | WG-095-27 | 1 |
| 15 | Short inlet connection | WG-095-28 | 1 |
| 16 | Fill valve | WG-095-36 | 1 |
| 17 | Self- tapping screw | WG-095-34 | 1 |
| 18 | Manuals | Installation Guide & | |
| User Manual | 1 |
Parts:
Notes:……
Notes:……
Wedmore Road, Cheddar, Somerset, England BS27 3EB
tel 01934 744466 fax 01934 744345
aftersales@vado.com
www.vado.com
Version 1, 1-12-22
References
- VADO | UK's leading manufacturer of bathroom taps, showers and accessories
- Water Regs UK Limited - Home
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>