FDFRaceshop S197 Mantis Angle Kit Installation Guide
- October 30, 2023
- FDFRaceshop
Table of Contents
FORD S197 MANTIS KIT
Installation Guide
S197 Mantis Angle Kit
Fully Assembled view of the s197 mantis kit is shown for the left side of the car
- KNUCKLE ASSEMBLY
- COMPRESSION ARM MOUNT
- LOWER CONTROL ARM
Bolt check regularly, take note of the orientation of all the components in this view
*do not exceed the rod ends adjustments, each rod end should have a minimum of 1 to 1.5x the diameter of the joint. (example, a ¾” rod end needs to have approx. 3/4”-1 1/8” inside of the arm at a minimum, this is 12-18 threads)
-ACKERMANN PLATES see image for the Ackermann plates. The kit will come
with zero Ackermann plates installed and include +2/-2 options that can be
changed out. Ackermann is the difference in angle measured at full lock.
Example- with 0 ackermann plates installed, the angle of the car will be 60 on
the inside wheel, and 60 on the outside. please note that alignment settings,
rack position and other variables can effect the Ackermann curve resulting in
differences from chassis to chassis, make adjustments according to your
individual setup
DETAIL NOTE- BUMP STOP BOLT AND CALIPER SPACERS- using the bump stop bolt, adjust the length to limit the angle. This is to avoid contact from the wheel to control arms or other components. Install the caliper spacers provided to re-use the factory caliper bolts.
Alignment Recommendations
Caster 6.5-7.5 + or – .5
Camber -4 + or -1.0
Toe 0-1/8th out
Wheel size recommendation 18×9 +10 offset (close to this size will work well)
For Racing
Use only
Not For Road Use
Must be installed by a licensed professional
fdfraceshopcustomerservice@gmail.com
+1(613)243-8859
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>