Totmizby B0C1GFRBW6 Wearable Electric Breast Pump User Manual

Totmizby B0C1GFRBW6 Wearable Electric Breast Pump

Congratulations on being a mother! If this is your first experience with a breast pump, it may take you some time to familiarize yourself with its usage.
It is important for you to relax during the process, even if you may not be able to express as much milk as you would like to at the start. Your body will adapt accordingly so that after several attempts, you will be able to express more milk.

PLEASE READ BEFORE USE

• Please limit usage lo no more than 15 minutes at a lime. II is perfectly normal to not express much milk within this period at first, but with regular use, your body will eventually adapt to producing more milk.
• Research has shown that to achieve optimum breast milk production, you should be in a totally relaxed state. It helps you release the hormone oxytocin that stimulates your let-down reflex for milk ejection. So, sit back on your favorite couch while listening to your favorite tunes, try deep breathing exercises, or get your partner to give you a massage.
• The device comes with a massage function that you may use ( 1-3 mins) before pumping. This allows you to release the hormone oxytocin and increase milk production.
• Clean regularly, clean any pump parts that have been in contact with your breast milk, and wash your hands before and after use.
• Choose the right optimum suction level. Gradually increase the breast pump suction until it becomes slightly uncomfortable, and then turn ii down a notch. The pump will resume from the last used suction level when restarted.
• Since this is a wearable breast pump, please ensure that you use a proper breast shield.

PRODUCT DESCRIPTION

Accessories Include

Pump motor•1| Valve •2
Milk collector •1| Sealing ring •2
Linker•1| Silicone gas cup •2
Type-C cable •1| Bra adjustment buckle •1
Silicone massage petal •1| Remote control •1

CONTROL PANEL

Follow the principle of massage first, then deep pumping.

3Modes

Massage function: 12 levels
(Massage first to stimulate milk production.)

Suction function: 12 levels
(Please choose the optimum level, the pumping mode is designed for slow suction and deep suction.)

Nipple correction: 6 levels
(Massage and suction are used simultaneously which is excellent for sunken nipples or first-time new mothers, open milk adopts 3 + 1 mode,3 short- frequency massages, and 1 deep suction.)

• Turn on/off: Press and hold the power button for 3 seconds.
• Mode change: Press the mode key .
• Level change: Press the and. keys to increase or decrease the level.

Battery Indicator and Milk Alarm
Flash Red: Battery low (require charging).
Glow Graen: Battery is fully charged (Flashes green while charging).
Milk Warning: The alarm will flash red every 10 minutes. It is time to take out the milk collector, the pump will auto off every 30 mins.

REMOTE CONTROLLER INSTRUCTIONS

Make sure that the breast pump is properly put inside the nursing bra, press and hold the power button of the pump motor for 3 seconds to turn it on, then align the remote controller above the pump motor and switch modes and increase or decrease the suction levels according to the buttons on the remote controller (as picture). After use, long-press the power button of the remote controller for 3 seconds to turn off the breast pump or long-press the power button of the pump motor for 3 seconds to turn it off.

ASSEMBLY

STEP 1
Put the silicone gas cup into the linker, and press it with your hands to make the edges fasten tightly to ensure a perfect seal.

STEP 2
Install the valve into the bottom of the linker. Make sure it is installed in the correct direction.

STEP 3
Put the assembled linker into the milk collector.

STEP 4
Place the silicone massage petal into the milk collector and ensure it is sealed properly to prevent leakages.

STEP 5
Install the pump motor.

CLEANING INSTRUCTIONS

Before Use

1. Remove the pump motor.
2. Place all the silicone parts in boiling water for 3 to 5 minutes.
3. Wash the milk collector and Linker with wann soapy water and rinse well.
4. Wipe down the parts with a cloth or air dry before use.

After Use

1. Rinse the milk collector, valve, and linker immediately after use.
2. Place all the silicone parts in boiling water for 3 to 5 minutes.
3. Wipe down the parts with a cloth or air dry before storage.
4. Do not submerge the pump motor in water.

SITTING POSITION FOR SUCTION

Relax the body, sit in a comfortable chair, and lean slightly forward(use 1 cushion to support the back). Make sure to keep the breast pump and milk 1 collector upright.

STRUCTIONS FOR BRA ADJUSTING BUCKLE

Adjust the length of bra straps to make suction more comfortable. One end of the bra adjustment buckle hung on the inside buckle of the nursing bra. The length of the bra strap can be adjusted by changing the nursing bra buckle on the other end of the bra adjustment buckle.

DIRECTION FOR USE

In the bra placement

Press the silicone massage petal finally against the breast, leave no gaps, and make sure your nipples are centered. Keep it upright. Be careful not to distort the position of the product and the chest, otherwise, the breast pump will not have suction.

Tum off and remove the Iha pump carefully

Note : Do not lie down while using the breast pump. If you feel any discomfort while expressing or notice blisters or chafing on your nipple or breast, try reducing the breast pump suction level.

POUR MILK

Please keep the breast pump upright, and remove the pump motor from the pump body carefully, to pour the milk into the bottle, make sure the gap of the milk collector is against the bottle’s mouth.

BREAST MILK STORAGE AND THAWING

Storage
Please use a clean and sterilized milk storage bag or a sealed milk bottle to store breast milk, Immediately refrigerate the milk to maintain its freshness.

Thawing
To thaw frozen breast milk, place it in the refrigerator overnight. In case of emergency, you may thaw the milk quickly and safely by placing the milk bottle in hot water or by using a food heater, However, it is important to consume the breast milk within 24 hours of thawing.

Wann Reminder 1

1. Avoid repeatedly freezing breast milk.
2. Do not mix fresh breast milk with previously frozen breast milk.
3. Remember to drain any remaining breast milk after each feeding.

Wann Reminder 2

1. Always check the temperature of the milk before feeding your baby.
2. Avoid using a miaOl’lave to heat breast milk as It can damage important nutrients and antibodies.
3. Uneven heating can cause local overheating and scalding, so heat the milk slowly and stir It well.
4. Never put the bottle in boiling water, as ii may cause cracking.

TROUBLESHOOTING

Weak Or No Suction

| . Check that the valve is properly installed. Charge the device before use.

3 . Check that the product is placed correctly, otherwise, the breast pump will not have suction.

---|---

Nipple Pain

|

1 . Massage first and adjust the comfortable suction level.

2 . Seek a lactation consultant or breastfeeding specialist for advice e.

No / Little Milk Expressed

| 1 . Find yourself in a comfortable position.

2 . If you’ve been pumping for 10-15 minutes, take a break and

try again at the right time.

3 . Ensure optimum suction level during use. 4 . Relax and try again.

Note: Please keep free to contact us if you have any product questions.

CUSTOMER SUPPORT

• if you have any questions, please feel free to contact us:
• US: BreastPump.vip@gmail.com.
• EU/UK: BreastPumpService@163.com.
• JP: BreastPump.vipservice@outlook.com.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>