Ipdoor QS-IE-ICRC001-1-06-H Ethernet Controller User Guide

Ipdoor QS-IE-ICRC001-1-06-H Ethernet Controller User Guide

Technical features

Al controller ICRC001

The ICRC001 controller can be connected to:

• 2 input devices (buttons)
• 1 load to be powered at 12 Vdc (lock)
• 1 actuator controlled by a clean contact (automatic gate)
• One or more devices connected via the RS-485 bus (QR code/NFC reader)
• One device connected via Wiegand (keypad/NFC reader)
• Up to 2 devices to be powered at 12Vdc

Data sheet

Installation

The ICRC001 controller is installed on the internal wall of the room, using a standard 503 box. It is powered through the PoE Ethernet network cable. Access device (reader) that is installed outside the room connects to the controller and receives power through a Wiegand or 485 cable. The lock is directly powered by the controller.

Installation Steps

Wiring

Connection of a Reader to perform an access

The IpDoor access control system offers various options for user authentication, including the use of QR codes, NFC cards, or PIN codes. Depending on the chosen method of access, you can choose to connect:

• ICA0065, for QR code and/or NFC reading (RS485 protocol)
• ICA0066, for PIN and/or NFC reading (Wiegand protocol)

To correctly connect and configure the devices into the IpDoor system, follow the instructions below.

ICA0066: NFC Reader + Keypad

ICA0066 is a 26-bit Wiegand reader that transmits a reading in 8H10D standard.

Wiring:

1. Wire a 4-wire conductor between the ICRC001 device and ICA0066.
2. Connect the two conductors to power the device at +12V and GND.
3. Connect the two conductors to control the device at D0 and D1.

ICA0065: NFC Reader + QR Code reader

ICA0065 is a 26-bit Wiegand reader that transmits a reading in 8H10D standard.

Wiring:

1. Wire a 4-wire conductor between the ICRC001 device and ICA0066.
2. Connect the two conductors to power the device at +12V and GND.
3. Connect the two conductors to control the device at D0 and D1.

Device Configuration in the IpDoor System

1. Visit “console.ipdoor.com”, register/login and access the configuration. Indicate the building where you want to install the device.
2. Add the device using the QR code in the package.
3. Add the access control license provided via its QR code.
4. Assign the license to the added device.
5. Create the desired access rules.

Available on

www.ipdoor.com

Manufactured by InfinitePlay S.r.l.
Via Giacinto Andrea Longhin, 131 – 35129 Padova (PD) Italy

Read More About This Manual & Download PDF:

References

• console.ipdoor.com
• IpDoor: Videocitofono Smart | IpDoor
• console.ipdoor.com/
• Download | IpDoor

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>