HySecurity Slidedriver II D1159 Fire and Emergency Access Lock Box User Guide

: June 11, 2024
: HySecurity

Table of Contents

SlideDriver II D1159 Fire and Emergency Access Lock Box
PARTS
HARDWARE
TOOLS REQUIRED
INSTALL THE EMERGENCY ACCESS LOCK BOX
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SLIDEDRIVER II FIRE AND EMERGENCY ACCESS LOCK BOX
User Guide

SlideDriver II D1159 Fire and Emergency Access Lock Box

The Fire and Emergency Access Lock Box provides a manual release mechanism for the gate and a microswitch that can be wired to the Smart Touch 720/725 Controller inside the SlideDriver II gate operator for Fire Department OPEN functionality.

PARTS

Fire and emergency access lock box and microswitch
Drive wheel compression spring
Handle release assembly
Pull cable and handle
Cable jacket
Cable jacket ferrule (x2)

HARDWARE

1/4-20 x 1/2 in bolt
1/4 in washer

TOOLS REQUIRED

Phillips-head screwdriver
Standard hex key set
Standard socket wrench set
Standard socket set
Needle nose pliers with wire cutter

CAUTION
Turn OFF power to the SlideDriver II and take the necessary precautions to avoid electrical shock.

INSTALL THE EMERGENCY ACCESS LOCK BOX

Remove the cover (Figure 1).
Open the gate.
Set power switch to OFF (Figure 2).
Carefully release the drive wheels.
Install the drive wheel compression spring (Figure 3).
Assemble cable release bracket (Figure 4).
a. Install cable clamp and loosely attach nut.
b. Assemble cable ferrule and tighten.
c. Assemble cable release bracket hinge and ensure that cable release still rotates.
Install the cable release bracket (Figure 5).
a. Remove the lower toggle handle nut and bolt.
b. Put the cable release bracket in place and install the lower toggle handle bolt/nut and the cable release bracket bolt/washer.
c. Make sure that the cable release bracket is securely attached.
Carefully engage the drive wheels.
Mount the Fire and Emergency Access Lock Box with the hardware provided, in an appropriate location, and with conduit to the SlideDriver II chassis.
Measure and cut cable jacket to length.
Feed cable through cable jacket. Stop when the cable reaches the end of the cable jacket.
Feed cable and cable jacket through conduit to the cable ferrule in the release bracket.
Leave 2 in (51 mm) of cable between the handle and the lock box cable ferrule. Leave 3 in (75 mm) of cable past the cable ferrule in the cable release bracket and cut the excess cable (Figure 6).
Route the cable through the cable clamp with 1 inch (25 mm) extending past the clamp (Figure 7).
Tighten the cable clamp.
Optional: connect microswitch COM and NC (the switch is held down by the lock box door) to Smart Touch 720/725 Controller Emergency Input (Figure 9) or wire to external access control system.
Note: Emergency Input is set to Fire Department Open by default. See Slide Driver II Digital Installation Manual for additional details.
Check red compression spring and adjust to 2 in if necessary.
Test the cable release and microswitch (if connected).
Reset the toggle handle and return Slide Driver II to normal operation.