WhatsGPS R12L 4G GPS Tracker User Manual

WhatsGPS R12L 4G GPS Tracker

Product Information

This product is an electronic device that complies with part 15 of the FCC Rules. It is designed to operate within specified radiation exposure limits set forth for an uncontrolled environment. The device should be installed and operated with a minimum distance of 20cm between the radiator and the user’s body. The product is subject to two conditions: (1) it may not cause harmful interference, and (2) it must accept any interference received, including interference that may cause undesired operation.

Product Usage Instructions

1. Reorient or relocate the receiving antenna to improve signal reception.
2. Ensure there is sufficient separation between the equipment and receiver to prevent interference.
3. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected to avoid interference.
4. During installation and operation, maintain a minimum distance of 20cm between the radiator and your body.

Failure to follow these instructions may result in undesired operation or void your authority to operate this equipment.

Statement
Thank you very much for using the Rl2L vehicle terminal (mobile user terminal) product. Please read this manual carefully before use. Please pay attention to all the cautions and warnings mentioned in the manual. Please keep this manual properly for reference.

This manual, as well as the description of the software, can be used or copied directly after receiving the license, only in accordance with such authority. The content of this manual is to provide information for use, subject to change without notice, and should not be regarded as a commitment by SEEWORLD. SEEWORLD assumes any liability or any deviation of legal liability that may appear in this book.

SEEWORLD Company reserves the right to make changes to specifications at any time without notice. SEEWORLD Corporation believes that this manual is accurate and reliable. However, SEEWORLD Corporation is not responsible for its use, or infringement of patents or the rights of other third parties caused by its use. Without a license, any patents or patent rights will belong to SEEWORLD.

Product Introduction

Rl2L positioning terminal is a feature-rich positioning terminal, with a wide application range. The equipment adopts an AT6558R chip and supports the GPS and beidou satellite system. Equipment in addition to supporting satellite positioning, also supports single base station and base station positioning. The expansion of the rich function can refer to the following related description of extended functionality.

Integrated with independent research and development of the hardware control circuit, makes the equipment long-term reliable and stable work, can automatically when abnormal return.

Main Function

• GSM quad-frequency, built-in GSM/GPS antenna; e Chip Specification: 4G Catl, Support 2&4G
• Support all deployed and soon-to-be-operational global navigation satellite system GPD, Beidou
• Support global multi-base station and satellite positioning mode
• Low Voltage Input: 9-l00v
• Built-in high-power surge protection circuit;
• The use of high-temperature resistant safety explosion-proof type rechargeable lithium cobalt acid battey
• Built-in high-power surge protection circuit;
• Built-in hardware monitoring circuit, abnormal state automatic recovery
• Remotely oil control
• ACC Detection
• Power off Alarm
• Vibration Alarm
• Movement Alarm
• Over-the Air (OTA)
• Waterproof IP65

Specification

(static current SmA)

| Not charging
Device size| L82mm W35mmH14mm|
Position model| GPS+BD+LBS|
Positioning accuracy|

<S Meters

|
communication network| GPRS|

LTE-FDD LTE-TDD

| C: B1/B3/B5/B8/B34/B38/B39/B40/B41 EU: B1/B3/BS/B7/B8/B20

SA: B1/B2/B3/B4/BS/B7/B8/B28/B66

GSM| 850/900/1800/1900MHz|
GPRS| TCP|
Working Temperature|

-20°(~ +70°(

|
Working Humidity| 5% ~ 95%|
Working Time| 0.5h|
Warranty| 1 year|

Appearance Diagram

By viewing the status indicator light can understand the performance of the equipment light condition stated below:

Blue

| Fast flash| GSM initialization
Slow flash| GSM receiving signal is normal
Normally on| GSM/GPRS online
Not Bright| No GSM signal received/ no card inserted

Green

| Fast flash| BD/GPS signal search
Normally on| BD/GPS Successful positioning
Not Bright| GPS is dormant/not working

Red

| Normally on| Switch on the external power supply
Not Bright| Disconnect the external power supply

lnstall Statement

Wiring definition

Connect to Powe of 12V/24V

V+| Red

Relay Connection Matters Needing Attention
Pump relay connection: For castor oil joints at the ends of the line (85) and thin yellow line (86). White line (85) is connected to the vehicle power supply (12 v). Yellow lines relay control line is connected to the equipment. Cut off the positive cable of the pump. Then series connected to the relay normally closed contacts (87 a) green thick line, and the other end is connected to the relay COM contact (green thick line 30).

Setting Common Command-List

Setting Common Command-List-1

1| SERVER,8520, I P, PORT#| T: primary server IP port, F: vice server port,*: interval operator (IP forwarding only master server data)
---|---|---
2| TIMER, Tl#| Tl :ACCON Back interval

Setting Common Command-List-2

Remotely cut off oil & power 

1| Remotely cut off oil|

RELAY,1#

|

When the car speed down to 20km/H, the instruction execution success

---|---|---|---
2| Recovery oil| RELAY,0#| Recovery oil

Installation Instruction

Troubleshooting

In the operation of the terminal, if feel the equipment is not normal, please refer to the following problems and solutions. If still cannot solve the problem, please contact the seller or service provider.

near tall buildings or basements, radio waves cannot be transmitted effectively| Use the terminal in the signal of good position
Unable to connect to the network| SIM card is not installed| Check the SIM card
SIM card metal surface dirt| Wipe with a clean cloth
SIM card is invalid| Contact your network service provider
Beyond the GSM service area| Please move to the network service provider service area
Common Problem| Reason| Solution
---|---|---
Unable to connect to the network| Weak signal| Please move to a place with strong signal and try again
Power Off| Please confirm the equipment whether to turn on the switch| Open the battery switch equipment
Please check the SIM is installed| Please insert the SIM card
Poor contact| Check whether the plug is connected well

Warranty Card

Maintenance record

Maintenance shop|
Sending date|
Fault description|
Maintenance situation|
IMEI number|
Maintenance Person|
Maintenance record

Maintenance shop|
Sending date|
Fault description|
Maintenance situation|
IMEI number|
Maintenance Person|

FCC STATEMENT WARNING

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference e to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution:
Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>