Malmbergs Elektriska AB HK16A 99 741 98 LED Driver Instruction Manual
- June 10, 2024
- Malmbergs Elektriska AB
Table of Contents
instruction MANUAL
LED Driver
HK16A 99 741 98 LED Driver
Read these instructions before starting the installation and hand it over to the user when finished.
APPLICATIONS
This driver is exclusively designed for LED lamps with 12v DC constant output
voltage.
The built-in protection circuit will shut down the power supply in case of
such faults as: short circuit, overload or overheating. The driver will
restart automatically after fault
correction.
IMPORTANT INFORMATION FOR INSTALLATION
- The unit uses mains voltage (220-240v AC), it should only be installed by a qualified electrician according to European safety standards and relevant national regulations. Failure to observe any of the installation instructions may cause fire or other hazards.
- The driver is for LED lamps only.
- Connect the LED lamps to the driver with correct polarity according to the schematic drawing.
- The indicated load should not be exceeded.
- The maximum length of the output cable to the LED lamps should not exceed 2 m in order to meet the EMC standard.
- if the LED driver is used for purposes other than originally intended or it is connected incorrectly, the manufacturer is not responsible for possible damages.
TECHNICAL DATA
| Input voltage: | 220-240v AC |
|---|---|
| Input frequency: | 50/60Hz |
| Output voltage: | 12v DC |
| Output power: | 0-60W |
| Ambient temperature ta: | -20ºC – +45ºC |
| Case temperature tc: | 90ºC |
| IP rating: | iP20 |
| No load consumption: | Pno ≤0.5W |
| Energy efficiency: | 88% |
Malmbergs Elektrische AB, PO Box 144, SE-692 23 Kuma, SWEDEN
Phone: +46 19 58 77 00
info@malmbergs.com
www.malmbergs.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>