Hythe 45w LED Amenity/Street Light Instructions

Table of Contents

The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than 0.58m is not expected

Hythe-45w-LED-Amenity-Street-Light-FIG-3 Hythe-
45w-LED-Amenity-Street-Light-FIG-5

Ensure no cables / wires are trapped during luminaire assembly.
Care must be taken when removing / fitting lumminaire retractor to prevent LED damage.

Circuit Breaker Type 10A B 16A (B) 25A (B) Standard Luminaire 7 12 20

Failed light source should be replaced promptly or the circuit switched off to avoid possible damage to control gear.

Important – Safety

ta -20°C … 40°C
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.

Example: IP junction box/ terminal block. If in doubt seek advice from qualified electrician.

Preparation of the ends of conductors: Wire ends striped to the length 7mm – 8mm. Add ferrules (for 1.5mm2 mini wires) to the wires if they are stranded.
Terminal block specified:
- Terminal block specified:
- The type of terminals: Screw.
- Number of terminals: 3
- Rated voltage: 450V
- Rated connecting capacity: 16A to EN60598 and 24A to EN60998

Example:

Example: Terminal block fused cut out. If in doubt seek advice from qualified electrician.

Preparation of the ends of conductors: Wire ends striped to the length 7mm – 8mm. Add ferrules (for 1.5mm2 ) to the wires if they are stranded.
Terminal block specified:
- Designed and tested in accordance with BS 7654:1997 and IEC/EN 6094 7-Part 1
- Detachable terminal block in extension trough facilitates termination of heavy duty cables
- Electroplated brass terminal blocks accept conductors up to 25mm2
- Number of terminals: 3
- The type of terminals: Screw
- Rated voltage: 230V
- Rated connecting capacity: 25A

Example:
Lucy zodion – Titan2 Single and double pole cut outs.

Hythe-45w-LED-Amenity-Street-Light-FIG-9 Hythe-
45w-LED-Amenity-Street-Light-FIG-10