i-Go INFINFB4386 Folding Mobility Scooter Mobility Scooters User Guide
- June 9, 2024
- i-Go
Table of Contents
i-Go INFINFB4386 Folding Mobility Scooter Mobility Scooters
Unfolding Your Scooter
-
Raising the Tiller:
Raise the tiller by pulling the tiller adjustment lever.
-
Disengage the Front-to-Rear Latch:
Disengage the front-to-rear latch to unsecure the front and rear sections.
-
Unfolding the Front and Rear Selections:
While holding the main pivot handle, squeeze the tiller release handle and guide it forward and away from the rear section of the scooter until it is in the driving position.
-
Unfolding the Seat:
Squeeze the seat release and then lift up on the seat until it is fully raised and in driving position.
WARNING! Ensure the seat is fully raised and secured in driving position prior to sitting on your scooter. Failure to do so may result in property damage and/or personal injury.
-
Unfolding the Seat Back:
Pull the locking pin and unfold the seat back to an upright position.
-
After Unfolding Scooter:
Ensure the manual freewheel lever is in drive mode. -
Install the Battery Pack:
Align the tabs on the new battery with the alignment holes. Press down on the battery pack until you hear a “click.”
NOTE: Ensure the battery strap is kept outside the battery compartment when installing the battery. -
Push breaker toward the rear of scooter. insert key into the switch and turn clockwise to start.
NOTE: To refold scooter, remove key, ensure the manual freewheel lever is in drive mode, and reverse steps 1 through 5.
Disassembling Your Scooter (Folded Position)
-
Disengage the Front-to-Rear Latch:
Disengage the front-to-rear latch to unsecure the front and rear sections.
-
Turn both pivot pins 90° so they are horizontal to ground.
-
Lift the front section of the scooter up and away from the rear.
NOTE: To reassemble scooter, reverse steps 9 through 11.