PitPat SSPHPPLIE Smart Bracelet User Manual
- June 9, 2024
- pitpat
Table of Contents
PitPat SSPHPPLIE Smart Bracelet
Assemble and wear the bracelet
-
Take out the bracelet body and wristband:
-
Put the bracelet body into the wristband:
-
Put the wristband on your wrist.
Note: it is best to wear the bracelet behind the styloid process of ulna. Adjust the size of the bracelet to suit the wrist according to the adjusting hole. The sensor should be close to the skin to avoid movement.
Install app on mobile phone
Search for .. pitpar· in the app store or scan the following QR code to download and install the app.
System requirements: ios13 or above; Android 6.0 or above.
Bind the bracelet to the treadmill
- Bracelet boot Long press the bracelet button, and the bracelet vibrates once to display the pitpat interface;
- Turn on the treadmill, put the screen of the bracelet on the NFC logo of the tread ill, the treadmill make a sound of “‘ bleep .. , and the bracelet is connected with the treadmill.
Once the bracelet is successfully bound, it will recording your running information immediately.
Note: The initial connection between the bracelet and the treadmill requires touching the NFC logo of the treadmill. After the first connection, the next time you start the bracelet, it will automatically connect to the treadmill.
Start using
Bracelet startup: in the shutdown state, long press the button, and the bracelet will vibrate then the pitpat interface will be displayed, and the bracelet will be powered on;
Bracelet shutdown: long press the bracelet button, the bracelet will vibra te then the bye interface will be displayed, and the bracelet will be shutdown.
- Standby mode:
When the bracelet is not connected to the treadmill or the treadmill is in standby mode {the treadmill stops moving], the bracelet automatically enters the standby mode. The bracelet displays the power of the bracelet in standby mode.
- Motion mode :
When the treadmill enters the running state. the bracelet will automatically
enter the sports mode.
① At this time, the main interface of the bracelet displays the heart rate,
steps and movement information. !in the exercise mode, the bracelet will
automatically detect the heart rate, and the heart rate detection light
flashes.] ② The bracelet displays the power and Bluetooth connection status.
③ Touch the display screen and the screen will be lit when the hand is in the
state of resting screen.
④ For other Bracelet click, double click and three click operations, please
refer to the instructions of pitpat app
Bracelet charging
Note: Make sure the bracelet is in normal power for the first time use. If it cannot be started normally in low power, please connect the charger to charge the equipment, and the bracelet will start automatically.
① Take the bracelet body out of the strap;
② Insert the charging head of the bracelet body into the USB charging port for
charging.
Note: some treadmills have a special use port at the meter. You can also plug it directly into the use port of the treadmill to charge.
Product parameters
Product model: pitpat-b01
Battery type: lithium polymer battery
Battery capacity: 90mah
Connection method : Bluetooth 5.0
Wristband materia l: Rubber
Equipment requirements: system requirements ios13
or Android 6.0 above
Screen size: 0.96 inch
WARNING
-
Please do not wear bracelets when bathing and swimming.
-
Do not expose the bracelet to high moisture, high temperature or low temperature for a long time.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>