Eulps GY-WC002A Wireless UHF Transmitter or Receiver User Manual
- June 4, 2024
- Eulps
Table of Contents
Eulps GY-WC002A Wireless UHF Transmitter or Receiver
Overview
Packaging Contents
- 1x UHF Wireless Receiver/Transmitter
- 1x Micro USB Charging Cable
- 1x 3.5mm to 6.35mm adapter
Wireless UHF transmitter/receiver
When the blue LED light is flashing, it requires for charging. the red LED light will be long time on during charging and then off when full charge the battery.( around 2-4hours)
Pairing
The wireless Microphone has been paired before putting in the box.
If the UHF receiver and transmitter are not paired , please follow the
instructions below:
- Turn off the UHF transmitter and receiver first and turn on the transmitter again and press and hold the power button for around 3 seconds, and then press and hold + – button immediately until the LED screen runs quickly (it goes into the pairing mode)
- Turn on the UHF receiver, when you see the blue LED light long time on, the pairing is complete.
- If you have more than one sets of wireless UHF headset microphones, please turn off the paired transmitter/receiver and continue to pair the next set according to the above operation method.
- To pair multiple sets of equipment to avoid the same frequency, you can choose from the frequency of C00-C49
Attention:
Please make sure the devices are powered off before manual pairing
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution:
Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>