Schneider Electric CCT592011C Wiser Water Leakage Sensor User Manual

: June 9, 2024
: Schneider Electric

Table of Contents

Wiser Water Leakage Sensor
Trademarks
- EU Declaration of Conformity
- Schneider Electric Industries SAS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Schneider Electric CCT592011C Wiser Water Leakage Sensor

Wiser Water Leakage Sensor

About this product

The Wiser Water Leakage Sensor (hereinafter referred to as sensor) has two sensing pads at the bottom of the body that activates when water is present between the pads.
The pads are close to the floor surface when the sensor is placed in its operating position.
When the sensor is connected to the Wiser Gateway and detects water on the floor, its reports an event to the gateway and also produces an alarm sound.

Choose suitable location to install

NOTICE

RISK OF DAMAGE TO DEVICE

Avoid locations where the sensor may be accidentally kicked or otherwise moved. The best locations are on the floor in corners, within cabinets with exposed plumbing, beneath cabinets, or other fixtures.
Do not locate the sensor right beneath the place where leakage is likely to happen.
Do not locate the sensor at the area with rain, oil smoke and steam of cooking range.
Do not install the sensor in a location with contaminated water such as oil or frozen water such as ice or snow.
Failure to follow these instructions can result in equipment damage.

The sensor should be placed where leaks are likely to occur. Most likely, this will be on the bottom level of your home or places like basement, kitchen, bathroom, balcony, bedroom, living room, utility room or any where you think leaks are possible.
Locations to consider
Floor drain, water heater, sump pump, washing machine, toilet, dishwasher, refrigerators, water purifier, water softener, sinks like kitchen sink, bathroom sink and other sinks, older pipes, heating radiator, bathtub, boiler, fish tank, etc.

Mounting the sensor

A Sensing pads

NOTICE

INOPERABLE EQUIPMENT
Do not completely immerse the sensor into the water.
Failure to follow these instructions can result in equipment damage.

Install the sensor so that the sensing pads are horizontal. A water leak can only be detected if water touches both the metal probes; if water touches only one of the probes, a water leak will not be detected.

Ensure that the sensing pads are close to the floor or the cabinet shelf.
Touching the sensing pads with your hand may trigger the sensor to send out an alarm signal. This is not a defect.

Read full device guide online

Scan the QR code and choose your language
for complete information about the device, including operation, configuration and using the product with a Wiser system

Technical data

Battery	3 VDC, LR03 AAA × 2
Battery life	Up to 5 years (may vary based on the usage, frequency of

Trademarks

Wiser™ is a trademark and the property of
Schneider Electric SE, its subsidiaries and affiliated
companies.
Zigbee® is a registered trademark of the Connectivity Standard Alliance.

Other brands and registered trademarks are properties of their relevant owners.

EU Declaration of Conformity

Hereby, Schneider Electric Industries, declares that this product is in compliance with the essential requirements and other relevant provisions of RADIO EQUIPMENT DIRECTIVE 2014/53/EU. Declaration of conformity can be downloaded on: se.com/docs.