truma Mover XT Manoeuvring System for Single Axle Caravans Instructions
- June 9, 2024
- Truma
Table of Contents
truma Mover XT Manoeuvring System for Single Axle Caravans Instructions
During operation
No button is pressed on the remote control for some time.
The safety plug is unplugged from the socket with the remote control switched on.
The on-board battery is disconnected with the remote control switched on
Problem with radio link while manoeuvring.
The remote control is switched off with the motors swivelled in.
The safety plug is unplugged with the motors swivelled in and the remote control switched on.
The on-board battery is disconnected with the motors swivelled in and the remote control switched on.
Warning
The charge of the on-board battery is low.
Protecting the battery
If the remote control is switched off for longer than one hour, the control unit goes into standby mode.
Display
LED 4 flashes 4 times, and an acoustic signal is heard 4 times. The remote control switches off after three minutes at the latest.
LED 4 flashes 4 times, together with man acoustic signal. Then the remoten control switches itself off.
LED 1 illuminates and LED 4 flashes 4 times, together with an acoustic signal. Then the remote control switches itself off.
LED 4 flashes 4 times, together with an acoustic signal. Then the remote control switches itself off.
LED 2 flashes short, together with an acoustic signal. Then the remote control switches itself off.
LEDs 2 and 4 flash, together with a beep. After some time, the remote control switches off.
LED 1 lights up and LEDs 2 and 4 flash, together with a signal tone. After some time, the remote control switches off.
LEDs 1 and 3 illuminate for one minute, together with an acoustic signal. Then the remote control switches itself off.
When the remote control is switched on again, LED 4 flashes slowly ten times, then flashes quickly four times with an acoustic signal. Then the remote control switches itself off.
Remedy
Switch off remote control at slide switch. Wait two seconds and switch on again.
Switch off remote control at slide switch. To continue using the Mover, plug safety plug in again and switch on remote control.
Switch off remote control at slide switch. To continue using the Mover, reconnect battery and switch on remote control.
Switch off remote control at slide switch. For better reception quality, move closer to the control unit. Avoid sources of interference such as radio signals reflecting from building walls or other radio signals. Switch remote control on again.
Switch on remote control again at the slide switch and swivel the motors out completely. Then switch the remote control of.
Switch off remote control at slide switch. Plug safety plug in again. Switch on remote control again at the slide switch and swivel out the motors. Switch the remote control off. The safety plug can now be unplugged.
Switch off remote control at slide switch. Re-connect the battery. Switch remote control on again at the slide switch. Swivel out the motors and switch off the remote control.
Switch off remote control at slide switch. Recharge the on-board battery.
Switch off remote control at slide switch. Unplug safety plug and plug in again or disconnect battery and reconnect. Switch remote control on again at the slide switch.
Start-up
-
Prerequisite: Parking brake applied; front wheel lowered; towing vehicle
uncoupled. -
If present: Switch on battery cut-off switch; insert plug into safety socket
-
N Switch on remote control and wait until LED 4 is permanently on in green (Note: The remote control switches itself off if it is not used after some time, LED 4 fl ashes in green four times and an acoustic signal is heard 4 times. To use the remote control again, switch it off and on again. After one hour without being used, see rear “Protecting the battery”)
-
Swivel in the Mover XT
-
Release parking brake
-
Manoeuvre to destination
-
Apply parking brake
-
Swivel out the Mover XT
-
Switch remote control off
-
Unplug plug from safety socket and plug into towing vehicle; switch off battery cut-off switch if present.
-
To continue driving: Couple to towing vehicle; wind up front wheel; release handbrake
References
- Function, operation and possible problems with the Mover
- Funktion, Bedienung und mögliche Probleme mit dem Mover
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>