Inter Link SAS PROVENCE 1 Low Coffee Table Instruction Manual
- June 8, 2024
- Inter Link SAS
Table of Contents
SAS PROVENCE 1 Low Coffee Table
Instruction Manual
“PROVENCE 1” COFFEE TABLE
Assembling Instruction
ART. NR: 20 90 15 12
EAN NO.: 40 10 340 29 51 23
ORDER #
PROVENCE 1 Low Coffee Table
For the assembly you need the tools shown above.
Warning
Do not move your piece of furniture if loaded. Doing so, your piece of
furniture could become instable, collapse, tip over, and/or cause serious
injuries.
Warning
Risk of breaking glass.
If your piece of furniture consists of glass handle it carefully during
assembling. Use eye and hand protection. Improper handling can result in cuts
or lacerations.
Important assembling suggestions:
- Before starting, please read our assembling instructions carefully and make yourself familiar with them.
- Follow our assembling instructions carefully.
- Compare the listed parts and fitting list to the contents of the cardboard.
- Prepare the necessary tools for assembling and make sure that the tools are in proper condition. Bad tools lead in some way to difficulties during the assembling.
- To make sure that the furniture will not be damaged or grated during assembling, prepare an adequate area and cover the floor with the cardboards or another soft pad (i.e. cloth or carpet).
- We recommend operating always with two or more people.
- Do not overwind screws. Check the screws from time to time and if necessary retight them.
- Keep the instruction and service sheets. Perhaps you will need them later on.
Maintenance advice:
For wooden furniture consisting of glass and steel or MDF and coated surface:
Wooden Furniture: Stains can be taken off with a soft, moistened cloth or by
using a special polish (available in supermarket and specialized stores). But
do not forget to wipe the surface with a dry and soft cloth afterwards.
Steel furniture:
The metal has a varnished surface. The material could show little
discrepancies in colour, clouds or stains due to the machine made production
which should not be a reason for a complaint.
If some metal parts have been twisted out of shape during transport, you could
carefully try to twist them into the original position. Please do not overwind
the screws and retight them from time to time.
MDF and coated surfaces:
MDF consists of wooden fibres (please read the a.m. instructions). Do not work
on the coated surfaces with knives or sharp objects, as this could cause
damage the material.
That should not be a reason for complaints afterwards.
Due to machine made production, the MDF parts can have sharp edges. You could
chamfer them with a fine standard sand paper. Please do it carefully in order
to make sure that you will not remove too much of the material.
Warning:
Carrying out the assembly is for adults only. Please, keep your children away
during assembling. Children might take small parts or fittings away or swallow
them up. During assembling it could also happen that parts of your furniture
fall down on your children. Please, therefore, protect them and make sure that
you carry out the assembling in their absence.
If your piece of furniture consists of glass, it should be handled carefully
during assembling. Glass can break at any time and cause injuries. Therefore,
you should protect your eyes and hands by wearing special clothing and safety
shoes, available in the supermarkets and specialized stores.
We are not liable for any material damage or injuries resulting from faulty
assembling. We are also not liable for any damage resultant from lack of
maintenance during use. (i.e. retightening of screws, and etc…). We are not
liable for any damage caused by faulty use or use against its purpose.
We wish you a lot of joy and pleasure with your new piece of furniture.
Your Quality Assurance Team by Inter Link SAS