KOOP TAMP-KIT Tamper Switch for an id5 or od5 Instructions
- June 3, 2024
- KOOP
Table of Contents
KOOP TAMP-KIT Tamper Switch for an id5 or od5 Instructions
TAMP-KIT
Tamper switch for an id5 or od5.
Mounting
- Install the tamper switch on the mounting box using the mounting screw included in the extent of supply (see also illustration above).
- Connect the cables of the tamper switch to an input of the module (e.g. EB3E2A-AUD or EB1E1A).
The polarity does not have to be taken into account for this.
NOTE: Configuration
The input of the module must be configured accordingly in the web interface of the Intercom station to activate the tamper detection (see the respective product manual).
Mounting instructions
- This kit shall be installed by trained and qualified personnel only.
- Only use recommended tools when installing this kit.
Extent of supply
- Tamper switch
- Mounting screw (M3x8, TX10)
- Short reference
Required tools
- Torx screwdriver (TX10)
Handling
Use the original packaging when transporting the device to prevent damage.
Observe the precautions for handling of electrostatic sensitive devices.
Disposal and recycling
Equipment with this symbol shall not be disposed of together with household or
commercial waste.
The directive 2012/19/EU on waste electrical and electronical equipment (WEEE)
is applicable in the European Union member states.
Manufacturer’s reference
This device complies with the European directives listed below by fulfilling corresponding standards:
• The restriction of the use of certain hazardous substances in electrical and
electronic equipment (directive 2011/65/EU)
Keep this description in safe custody.
Type: D-BZ-TAMP-KIT, Version: 1.0/0322
Commend International GmbH, Saalachstraße 51, A-5020 Salzburg – www.commend.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>